Very nice. Before watching this I simply put my coil to the farthest distance and tightenen the screws. Ignorance. When I started it (and it did start) it reved and stopped. Thanks for sharing. I'll go out and adjust it. .
Thanks for the tip; I found your video at the perfect moment, as I put my Stihl 193T back together with the coil tight up against the magneto and when I went to pull the start cord, it wouldn’t budge to my surprise!
IGNITION. All engines are equipped with an electronic ignition system. The ignition coil and electronic circuitry are contained in a one piece ignition module (10-Fig. MC130), which is serviced as a unit assembly. Air gap between the flywheel mag-nets and the laminated legs of the module should be 0.010-0.015 in. (0.25-0.38mm). Loosen ignition module mounting screws and move module to obtain desired air gap. If air gap is excessive, engine may bie hard to start or may not start.
You confirmed the gap I haven’t had to adjust one in decades and I was thinking it was a business card. Thanks
Excellent video. Its a shame 19k+ views and only 124 likes….. very thankful
Very nice. Before watching this I simply put my coil to the farthest distance and tightenen the screws. Ignorance. When I started it (and it did start) it reved and stopped. Thanks for sharing. I'll go out and adjust it. .
Thanks for the tip; I found your video at the perfect moment, as I put my Stihl 193T back together with the coil tight up against the magneto and when I went to pull the start cord, it wouldn’t budge to my surprise!
Great video simple is always better thank you .May the wind be always at your back and the road rise up to meet you
thanks for the video, simple is better.
Thanks 2 guys like you. Showing us green horns how things go together. Big thumbs up!
Your trick worked!! Outstanding!! Thanks for sharing your knowledge :-)
Thank you! The contacts are curved than a feeler Gage is flat. The business card I have is approximately 13 tho
Check your spec sheet. My saw calls for 18 thou
IGNITION. All engines are equipped with an electronic ignition system. The ignition coil and electronic circuitry are contained in a one piece ignition module (10-Fig. MC130), which is serviced as a unit assembly. Air gap between the flywheel mag-nets and the laminated legs of the module should be 0.010-0.015 in. (0.25-0.38mm). Loosen ignition module mounting screws and move module to obtain desired air gap. If air gap is excessive, engine may bie hard to start or may not start.
What is the thickness of that 'card'?
Thanks for the video, really helpful. What grit sandpaper did you use? 300 or something?
I think he used 220 but most any will work. Just dont get to coarse.
Tidy little video. Thanks for sharing
Spot on great tips! 👍🔧
Thanks boyow
What is the gap between the coil and is it 14,000 or 13000
What is between the coil
Video is too long. This could be done in 2 minutes.
Thanks boyow
Thanks boyow