Calcium Reactor Setup and Tuning 👍

Fear no more the calcium reactor. If you have setup your Apex, dosing pumps etc etc then you can setup and tune a calcium reactor. In this video I will go over the equipment needed, setup and tuning of your calcium reactor so you too can benefit from what they have to offer for your system.
Would you like to buy frags direct from my system? Well now you can If you're located in Canada!!! Just follow the link below to my website
www.niagarafirecorals.ca/
Be sure to hit the subscribe, like and notification buttons to support the channel and help it grow and so you always see whats new coming out from Niagara Fire Corals.
You can also help support the channel with the link below "Buy me a coffee" Gosh knows I drink enough of it and I thank you.
www.buymeacoffee.com/Shandley65b

[@andrewgutt276]

Best calcium reactor guide period

[@niagarafirecorals]

Thank you 👍

[@rolisreefranch]

Good vid. Good explanation. Tx.

[@trainsandthings]

Great info thanks for sharing

[@trainsandthings]

Just started with my calcium reactor great info, best info I have seen

[@andrewgutt276]

My problem is consistency of the ph probe reading with apex

[@niagarafirecorals]

Maybe try recalibration

[@andrewgutt276]

@@niagarafirecorals problem I am having is at the connection to the apex. I got some crc entropic connector cleaner and it seems to help. Also my probe is 3 years old haha

[@niagarafirecorals]

Lol, that would do it.

[@trainsandthings]

got my aquamaxx calcium reactor setup like yours, whats the trick in getting the air out, i can't get the circulation pump chambers and top area to fill all the way up , space at top won't fill, thanks in advance

[@niagarafirecorals]

I attached a piece of RO line at the highest fitting. Then held it up and continued filling it until the water came out of the RO line which left the chamber full no air. However, if you just leave it, the air will work its way out in time.

[@trainsandthings]

@niagarafirecorals ok, I just have the kamoer pump running, should I turn on the circulation pump also because when I had it on its noisy and gurgling because it's no full of water , also should i have the kamoer pump full go or not, I have it pulling not pushing

[@niagarafirecorals]

@trainsandthings as long as the pump is pumping water it's fine to turn on. Just don't run it dry. The gurgling will eventually work its way out

[@trainsandthings]

@niagarafirecorals thanks for your help, I figured it out, that pre-filter cylinder was suckin air in the top connector, wasn't holding pressure, changed it and now it's working, thanks again

[@niagarafirecorals]

@trainsandthings ya I took that off and don't use it 👍