Watch the part at 1:20. Pull up from the back. It will take some pressure. Slide forward. There are 3 locations for them to snap into for your preferred position when putting them back.
This set up is: front- plus 12, rear- minus 9 and the stance is ~23.5” wide but there are little triangles marking on the board between inserts which are “reference” you can default to that and go wider if you like
sweet that’s usually what i’m riding but i’ve been playing around with my stance lately and i just got this board so i was curious. thanks for the reply!
Thanks homie! Saved me a trip to the shop
Saved my bacon. I unscrewed the two back screws and pushed up on the heel of the foot pad until it popped up and revealed the mount port
Wow, my dream setup!
10/10 would recommend
The footbed, should come out easly? or you put some force at 1:20 , because my girfriend have some Battaleon Dona`s and I am afraid not to break them?
Pull straight up with some force it’s just two small pressure clips and then it folds upwards
I feel so stupid rn but I'm really struggling to figure out how to remove the footbeds from the Bataleon Astro Fullwraps
Watch the part at 1:20. Pull up from the back. It will take some pressure. Slide forward. There are 3 locations for them to snap into for your preferred position when putting them back.
Check out my comment too, I got blasters
Thanks! Yup, just needed to push harder (upward on the heel).
How did you remove the foam pad?
1:20 my dude
what stance did you set the bindings too?
This set up is: front- plus 12, rear- minus 9 and the stance is ~23.5” wide but there are little triangles marking on the board between inserts which are “reference” you can default to that and go wider if you like
sweet that’s usually what i’m riding but i’ve been playing around with my stance lately and i just got this board so i was curious. thanks for the reply!