Hi I have a 2011 fiesta and have the same problem, i got it checked by a mechanic and advised either i spend a lot of money for a new abs module or just leave the problem and just to drive carefully since abs is not working anymore. My question is, if I leave the problem would it cause any harm to the vehicle?
I have a doubt, I have a 2011 Ford fiesta and the front right caliper is stuck, but there arent any code, just the brake the caliper stuck, what it could be? Maybe bad caliper or one valve inside of the abs is stuck...
My Ford Fiesta 2011 had a trouble code U0423 for a months ago. I didn't give an attention for it since the car is running normal condition. Recently, I noticed the brake in the front left was sticking up. The fluid pressure won't release even I released the brake pedal. I checked already the piston on the caliper and fluid lines but everything seems fine. My question is. is it possible that the ABS ECU was the cause of sticking up the brakes on front left?
Yes, you need access to either Ford IDS i.e. a Ford dealer or Forscan on a Windows device, so you can use the 'ABS bleed" functionality. The traditional method of bleeding the brakes won't work because it won't include the mechanical area of the ABS module that are now full of air. The 'ABS bleed' functionality opens each section in turn i.e. a caliper at a time, and pumps brake fluid through to push out any trapped air.
Hi my friend . I have got a working tested part, complete part from ford UK same serial numbers etc. I took it to a garage in Thailand, pattaya , that just plugged in and said, it's no good , bad code, I believe they did nothing. I took it all back. ( I saw the part tested in the UK, taken from a vehicle with no codes) Anyway, could the error codes be eradicated by replacing the electric module only ?? I have no facility other than a Ford garage to bleed brakes and pump. Thank you Many blessings happy songkran
Hi, i got abs, esp and engine light. Got diagnostic check and it says left front abs sensor. I changed that one and wheel bearing but still have the same problem and same fault. Can it be the abs module i need to replace?
@@carscarscars186 thankyou, our car drives normally but has these lights, at first intermittent, now on all the time...obd2 elm 237 no codes detected, no matter the app. Any ideas or is it ultimately the module?
@@seekkkkkkkkk7366 ELM327 won't help you. Why do you think we use expensive professional equipment and not a $5 butt plug LOL Take it to any decent garage or to a dealer and ask to scan ABS for errors, then let me know the codes.
Hello sir, I've got a 2016 ford fiesta sports(push start). I have 3 lights on my dash one of them is the abs,traction control and the brake light on. I was wondering if you could give me advice on which parts of the car could be causing this problem. I don't have a scanner tool to reset the codes. Do you think this could me a bad abs module? It would me a lot to me if you respond to my message. Thanks in advance!
The only advice I can give you is visit a Ford specialized garage (or a dealer) and ask them to run diagnostics on your car. It can be anything from blown fuse to abs sensor to abs module itself.
@@carscarscars186 firstly thanks for responding. I am planning on taking this to the dealership but i don't feel safe driving the car for 10 hours in the condition that it's in. I live quite far from the capital. You've mentioned something about being able to drive the car without the abs sensor. If i were to remove it while i wait for the parts or maybe ship you the abs sensor would this be safe to drive? And does removing the abs sensor get it of the acceleration lag for the time being? And i apologize if i am naming the parts wrong. I'm currently in the Philippines on vacation but i normally live in the states where good me mechanics/shops are only a stone throw away. Thanks again
Pull cover bottom towards you and up. it will come off. Then pull up 2 vertical slide locks on the top. They don't move easily, so pull them up bit by bit.
Hey, when you remove the electronic unit from the assembly and keep the hydraulic unit installed in the vehicle, will the vehicle have normal mechanical/hydraulic braking? Is the vehicle drivable?
hi sir I'm from Philippines I have problem with my abs module in my fiesta 2014 1.5/AT can you repair this how to keep in touch with you sir or do you know someone here in the philippines know how to repair abs module tnx
Hi I have a 2011 fiesta and have the same problem, i got it checked by a mechanic and advised either i spend a lot of money for a new abs module or just leave the problem and just to drive carefully since abs is not working anymore. My question is, if I leave the problem would it cause any harm to the vehicle?
sir after replacing engine mount, wheel sensors, brake pad, rubber cap of ford fiesta 2011, all wheels got sticked, what is the cause ABS Module?
I change brek fuild, after 1 weeks ABS alarm, the car cannot auto brek at incline position
I have a doubt, I have a 2011 Ford fiesta and the front right caliper is stuck, but there arent any code, just the brake the caliper stuck, what it could be? Maybe bad caliper or one valve inside of the abs is stuck...
My Ford Fiesta 2011 had a trouble code U0423 for a months ago. I didn't give an attention for it since the car is running normal condition. Recently, I noticed the brake in the front left was sticking up. The fluid pressure won't release even I released the brake pedal. I checked already the piston on the caliper and fluid lines but everything seems fine.
My question is. is it possible that the ABS ECU was the cause of sticking up the brakes on front left?
It is more than likely.
@@carscarscars186do any belts have to removed when replacing module on 2014 ford fiesta ?
When you reinstall the module. Do you need to bleeding the brake oil and add oil? Or it is just plug n play?
Yes, you need access to either Ford IDS i.e. a Ford dealer or Forscan on a Windows device, so you can use the 'ABS bleed" functionality. The traditional method of bleeding the brakes won't work because it won't include the mechanical area of the ABS module that are now full of air. The 'ABS bleed' functionality opens each section in turn i.e. a caliper at a time, and pumps brake fluid through to push out any trapped air.
I dint have an error code but the check valve seems to be stuck the brakes wont unlock
Hi mate do u have to bleed break after
Do u have to bleed break after
@@marklewis2517 yes
Hi my friend . I have got a working tested part, complete part from ford UK same serial numbers etc. I took it to a garage in Thailand, pattaya , that just plugged in and said, it's no good , bad code, I believe they did nothing.
I took it all back. ( I saw the part tested in the UK, taken from a vehicle with no codes)
Anyway, could the error codes be eradicated by replacing the electric module only ??
I have no facility other than a Ford garage to bleed brakes and pump.
Thank you
Many blessings happy songkran
How much its cost in MALAYSIA CURRENCY?.
kylangan po palitan yung abs module ng car ng ate ko pero sa casa lang daw pwede napakamahal.
Hi, i got abs, esp and engine light. Got diagnostic check and it says left front abs sensor. I changed that one and wheel bearing but still have the same problem and same fault. Can it be the abs module i need to replace?
I am having the same situation with my Rear Left abs sensor, how it's going for you have you fix it?
Hallo ..you have module abs ford fiesta 2011 sir..second and function
Part number?
@@carscarscars186 AV59-2C405-EA
A426G
GERMANY
At 10.0212-0728.4
@@carscarscars186 I share on your Instagram sir..
What's the head's number of the 4 screws of the black electric part ?
it's there in the video. T20 torx
I have seen brake pedal switch can cause same issues. Is this correct?
Not quite. Broken switch can make your shift lever stuck in P position, but will not cause U3000.
@@carscarscars186 thankyou, our car drives normally but has these lights, at first intermittent, now on all the time...obd2 elm 237 no codes detected, no matter the app.
Any ideas or is it ultimately the module?
@@seekkkkkkkkk7366 ELM327 won't help you. Why do you think we use expensive professional equipment and not a $5 butt plug LOL Take it to any decent garage or to a dealer and ask to scan ABS for errors, then let me know the codes.
@@carscarscars186 ok
Where in thailand are you please
May need to see you ,👍 we are in thailand pattaya
@@carscarscars186 where u based in thailand.
Hello sir, I've got a 2016 ford fiesta sports(push start). I have 3 lights on my dash one of them is the abs,traction control and the brake light on. I was wondering if you could give me advice on which parts of the car could be causing this problem. I don't have a scanner tool to reset the codes. Do you think this could me a bad abs module? It would me a lot to me if you respond to my message. Thanks in advance!
The only advice I can give you is visit a Ford specialized garage (or a dealer) and ask them to run diagnostics on your car. It can be anything from blown fuse to abs sensor to abs module itself.
@@carscarscars186 firstly thanks for responding. I am planning on taking this to the dealership but i don't feel safe driving the car for 10 hours in the condition that it's in. I live quite far from the capital. You've mentioned something about being able to drive the car without the abs sensor. If i were to remove it while i wait for the parts or maybe ship you the abs sensor would this be safe to drive? And does removing the abs sensor get it of the acceleration lag for the time being? And i apologize if i am naming the parts wrong. I'm currently in the Philippines on vacation but i normally live in the states where good me mechanics/shops are only a stone throw away. Thanks again
@@keepitsimplesilly3212hi, did you find out what was the problem?
Do you repair the module yourself? If yes, how could I conatct you please?
Yes I do, contacts on the intro screen.
How to Ulplug the Socket cable to ModuleABs i cant saw thanks
Pull cover bottom towards you and up. it will come off. Then pull up 2 vertical slide locks on the top. They don't move easily, so pull them up bit by bit.
thanks Done Already
@@troaspect8622 You're welcome.
Is the number or letter code of abs should be with the previous abs ?
Yes, unless I reprogram it.
Do you also repair leaks from the ABS pipes?
Never seen such a thing.
Hey, when you remove the electronic unit from the assembly and keep the hydraulic unit installed in the vehicle, will the vehicle have normal mechanical/hydraulic braking? Is the vehicle drivable?
It usually is. I used to drive my own car like that for few weeks LOL
@@carscarscars186after that u reinstall the electronic?.
@@carscarscars186after that u reinstall the electronic?.
hi sir I'm from Philippines I have problem with my abs module in my fiesta 2014 1.5/AT can you repair this how to keep in touch with you sir or do you know someone here in the philippines know how to repair abs module tnx
You can send it over and I will repair it. The car can drive OK without ABS electronic control part.
Sir same problem here, napagawa nyo nb fiesta nyo?
Hi. Na repair po ba?
Loc po sk mgkano pagawa tnx
Is this the cause of mushy brakes?
Sure not.
what is the price in thailand abs pump this..??
Repair 7500, replacement unit 9500
@@carscarscars186 can I order this abs .. ??
@@pendysimilikiti1704 What's the part number you need?
@@carscarscars186 AV59 2C405 CB
@@pendysimilikiti1704 You contact me on Line or Instagram.
Did you bleed the brakes before removing abs?
That battery came out way to easy
So they usually do LOL
@@carscarscars186 I ve worked on some cars you need a degree and a crane to get out, ha
How about in phillipines?
No idea but you can send your abs module over.
@@carscarscars186 i have to dismantle it?
@@Gettingjiggywithit228 Well, unless you want to send the whole car - yes, you do.
@@carscarscars186 lol😅
How much for a repair
Sir pano ka makontak hehehe pagawa ko din sana ung ecosports po
Да, можешь.
#bengkeltomoprobolinggo present
Gucci brand it is for poor people to look like rich.. umm Gucci.
Who's the music by