How to modify your PS4 Slim using a old graphics card heat sink

Hello Welcome to how do modify on PS4 Slim using a old graphics card heat sink
Disclaimer: This is on your own advisory if you don't have the skills or you don't know how modify or repair of general maintenance you will damage your own equipment!

[@safetmukanovic2857]

Your brain did go in the right direction, at least at the beginning when you filled those holes with solder, which does transfer heat greatly. There was a risk of warping the shroud and thus damaging the ram chips when you put it back on the motherboard, but that's fine. All what you should have done is: when you filled the holes with solder, level everything up with sandpaper and apply thermal paste the size of the new heatsink and make two little holes for screws so you can screw down that heatsink. You method actually didn't help because you added more metal that will accumulate heat and surface area (solder) between the shroud is small, didn't fill all the surface between the shroud and the heatsink (thermal paste would be perfect), thus destroying every effort you made in the right direction. I'm not an expert, I do electronics, so heat accumulation and dispersion is one of the main problems I face daily.

[@MrEvilpanda69]

This video needs a don’t not try this at home disclaimer

[@joshuathomas4934]

Why would you do this? Just clean the console out and do new thermal pads and paste. This is useless.

[@wongcw4787]

there are 23:56 minutes that I can't get it back in my life

[@SleepGoodyall]

😂

[@smaqdaddy]

Dude! You sound like Abe from Oddworld!

[@gocevoyevoda8847]

I was wondering about the familiar voice

[@theevee1995]

A thermal paste on the heatsink was enough no need to solder it

[@F14foreverF14]

14:54 Dual-Heatsinks baby! Epic!

[@BB0Y0]

I'm sorry but the way he says nut is priceless jolly good show 🤣🥜

[@francesmegliorino9884]

That’s why I have you as a friend so you can do it for me. Lol

[@fuckthisaccount8133]

Filling those holes isn’t good. That’s why heat syncs are built to be layers of THIN meta. So now when those heats up it’s gonna be 2x herder for them to cool . .

[@Ctrl_Shift_Studios]

Thats what i was going to say XD

[@jaketapgameplay2345]

get a toothbrush to clean with loquoer thinner on your heatsink dirt but the worst is u put on top of the metal on your heatsink i think 10 percent only on heat deduction

[@joejones6968]

This is absolutely fail on every aspect of heat dispersion. Horrible.

[@_chef_boyrd_7454]

Do they come with one of those from factory? Mine didn't and it overheated so much that it sumitted cuiside

[@LYkOn-001]

por dios que desastre XD limpia el flux! y usa pasta termica para pegar el disipador! habras dejado un monton de porqueria y burbujas de aire debajo del disipador y asi sera muy poco eficiente

[@westinmcleod]

What was the point of this ?? Why solder a heatsink directly to something too lmfao.

[@Allangulon]

Thermal paste is used to compensate for gaps from cheap manufacturing processes.
Mineral oil has 10-30 times the thermal conductivity of thermal paste when a proper flat mating surface is utilised!

[@iyeetsecurity922]

Bruh.....

[@Dylan-hc2lu]

Lol

[@djeeee911]

Damn