I'm using the VP5700 Vibrance clear. I'm usually spraying 4 coats and do see some wave but I'm initially cutting with P600 first then stepping out the grits to 3000 and using wool pads to buff( I know, old school) but get the best results. I used to get the cellulite after buffing but hot on the 600 or 800 and fixed that issue. When I found these videos it was confirmation on what I suspected. It's a lot of sanding but the pay off is there. 6 or 8 is the ticket.
Man I've been doing body/paint for 40 years...never seen or heard of these blocks..!!
They won’t send 2050 to California! Dammit
Normally you would start witrh epoxy then end with 2050 right?
Why are the rings falling off my 24 flex?
What sealer do you guys like to use?
Wihen u apply the 4 coats of clear do u find u get some urethane wave?
If so when u cut it with 800grit will it remove the wave if u have any?
I'm using the VP5700 Vibrance clear. I'm usually spraying 4 coats and do see some wave but I'm initially cutting with P600 first then stepping out the grits to 3000 and using wool pads to buff( I know, old school) but get the best results. I used to get the cellulite after buffing but hot on the 600 or 800 and fixed that issue. When I found these videos it was confirmation on what I suspected. It's a lot of sanding but the pay off is there. 6 or 8 is the ticket.
So you are using VP 2050 over body filler as well?
Where are these blocks sold?
www.linearblockingtools.com
finishmaster
thespraysource.com
5310 tamco on the roof before you got it?
I CAN'T HEAR YOU!!!
Thank you
Man you are awesome. I’m learning a hell of a lot by watching your videos. Keep them coming. 👍🏻👍🏻