DIY tailstock die holder
HTML-код
- Опубликовано: 6 июл 2023
- I wanted to replace my aging and pretty rough tailstock die holder. This is the story of how and why.
Drawings available from here:- www.homemadetools.net/forum/l...
Chanter - Vadodara by Kevin MacLeod is licensed under a Creative Commons Attribution 4.0 licence. creativecommons.org/licenses/...
Source: incompetech.com/music/royalty-...
Artist: incompetech.com/
Light Awash by Kevin MacLeod is licensed under a Creative Commons Attribution 4.0 licence. creativecommons.org/licenses/...
Source: incompetech.com/music/royalty-...
Artist: incompetech.com/ - Хобби
Very nice! Excellent work.
Thank you! Cheers!
For tapers too short to eject from the tailstock. Put a ball bearing in first. After ejecting, the ball just comes rolling out. I keep one on a magnet on the tailstock.
@markrainford1219
Clever idea hadn't thought that!
Cheers
An adjustable screw at the end of the taper on the old holder would have sufficed.
Yes it would but after years of pulling it out of the tailstock with pliers its as rough as a bears bum!
I must admit all that 'music' is very distracting.....
Thanks Matt, point taken!
That's the problem with spending so many years in broadcast if its dead air cover it with music!
I will be a bit more minimal in the future.
Cheers