for Sergio and George Pineda. Sergio, water may enter from several areas..... prop shaft seals are one, and the eccentric piston seal is an even more likely suspect. NOTE: When removing the eccentric piston, the shift detent pin must be removed. You will see two different style detent spring pin installations. ..... one detent spring pin is perpendicular to the eccentric piston. (this one is driven out and will be in plain sight) ..... one detent spring pin is parallel to the eccentric piston. (this one is driven further into it's bore. oil film tends to hold the spring pin in it's bore) The parallel detent spring pin must be retrieved. Spray something like carburetor cleaner into the bore, and then tap it out. If it is NOT retrieved, future spring pin removal cannot occur. See post # 11 here. Click on the image at the bottom of the post. www.baylinerownersclub.org/forum/current-topics-gc6/technical-discussion-gc12/617997-94-with-volvo-penta-dp-c-u-joints-and-yoke-shaft George, click on the hyperlink below, and look at post # 15 for the dimensions for my puller tool. (I am 2850Bounty on this forum) www.baylinerownersclub.org/forum/current-topics-gc6/technical-discussion-gc12/528223-aq280-not-engaging-prop
George, if you have any questions, ask away. www.baylinerownersclub.org/forum/current-topics-gc6/technical-discussion-gc12/656633-pinging-john-48-re-aq-series-vp-prop-shaft-bearing-carrier-puller-tool
For anyone second guessing it, this is correct....they have to be placed back to back... thank you for posting the video!
Great vid. 2850 has been a life saver over VP stuff!
Thanks for posting. Do you have any measurments on diameter and drilling points on the puller you made?
Awesome thanks, just doing mine now, as you say, a little heat and it pops right off. Happy Days :)
Hello, is it the 2 small oil seals that cause the water to enter the oil? thank you (french)
see my recent post 10-18-2022
.
for Sergio and George Pineda.
Sergio, water may enter from several areas..... prop shaft seals are one, and the eccentric piston seal is an even more likely suspect.
NOTE: When removing the eccentric piston, the shift detent pin must be removed.
You will see two different style detent spring pin installations.
..... one detent spring pin is perpendicular to the eccentric piston.
(this one is driven out and will be in plain sight)
..... one detent spring pin is parallel to the eccentric piston.
(this one is driven further into it's bore. oil film tends to hold the spring pin in it's bore)
The parallel detent spring pin must be retrieved.
Spray something like carburetor cleaner into the bore, and then tap it out.
If it is NOT retrieved, future spring pin removal cannot occur.
See post # 11 here. Click on the image at the bottom of the post.
www.baylinerownersclub.org/forum/current-topics-gc6/technical-discussion-gc12/617997-94-with-volvo-penta-dp-c-u-joints-and-yoke-shaft
George, click on the hyperlink below, and look at post # 15 for the dimensions for my puller tool. (I am 2850Bounty on this forum)
www.baylinerownersclub.org/forum/current-topics-gc6/technical-discussion-gc12/528223-aq280-not-engaging-prop
Link for that puller please 🙏
George, if you have any questions, ask away.
www.baylinerownersclub.org/forum/current-topics-gc6/technical-discussion-gc12/656633-pinging-john-48-re-aq-series-vp-prop-shaft-bearing-carrier-puller-tool