Evinrude ETEC G1 60 Degree Electronic Water Pressure Sensor Install
HTML-код
- Опубликовано: 20 окт 2024
- In this informative video, you'll learn how to install an electronic water pressure sensor on your Evinrude ETEC 60-degree six-cylinder motor. Specifically, we'll be working with a 2009 150 HO Evinrude ETEC. Attaching this sensor to the EMM and the NMEA 2000 network lets you easily monitor water pressure in real-time. It is hooked to a Lowrance Elite FS 9 via NMEA 2000 network. Whether you're a seasoned boater or just starting out, this video will provide valuable insight into ensuring water pressure. Without water pressure, your motor will overheat and may seize.
I'll be sharing the parts I used for this project. I've included all the links below, so you can easily find them if you want to try this out for yourself.
Water pressure sensor: www.amazon.com...
Brass Fitting Coupler 1/4-Inch Hose Barb x 1/8-Inch Female NPT: www.amazon.com...
1/8" x 1/8" NPT Male Pipe Thread Adapter: www.amazon.com...
Brass Barbed Tee: www.amazon.com...
¼ ID Fuel Hose: www.amazon.com...
Otiker Clamps: www.amazon.com...
Waterproof Terminals: www.amazon.com...
Hope this helps, and let me know if you have any questions in the comments below!
nice video nice explainations. my 012 175hp doesn't have this sensor just a hose to the mechanical gauge. so I guess when I connect the NMEA2K I'll still be using the old gauge.
I use both. I put in a tee so that I have redundancy using both the old analog gauge and the NEMA 2K on my graph
Awesome video. Can't wait to add this to my 115 E tec. Did you have to go in with Diagnostic Software to enable the water pressure output signal from the EMM?
Yes, you have to enable it with Diagnostic Software.
Is there a reason you used 1/4 hose not 1/8 hose for the whole setup?
Thanks for the comment. I used the 1/4 hose for Strength, longevity, availability and durability with the heat and vibration under the cowl. I wanted to do it once and never touch it again.
does the red go to red, black to black, and green to pink
Yes Red to Red, Black to Black and Pink to Green
Will that part make the hot alarm go off?
No, It will only give the digital water pressure
@@BrianB_fishing my 250 keeps sounding a hot alarm. But stream of water is good.
@@James-bb2ke Could be thermostats, water pressure relief valve, blockage somewhere, or sensors. Does it happen at low RPM or higher RPM? If low, could be the thermostat. If high it could be the water pressure relief valve. Do you have a water pressure gauge?