2005 Toyota Tundra taking apart rear axle to replace the bearing
HTML-код
- Опубликовано: 6 сен 2024
- We will be pulling the rear axle shaft assembly off, having the bearing replaced and put it all back together. (will not be pressing in or removing the bearing in this video, a machine shop did it)
PayPal for one time donations:
www.paypal.com...
I would recommend ordering NSK bearing or atleast original toyota oem.
NSK bearing:
rover.ebay.com...
Original toyota bearing service kit:
rover.ebay.com...
There are 2 bolt holes in the drum...take long bolts , turn them in and the drum is removed easier. The long bolts are used to hold the drum like handles.
Sure would be nice to know exactly how the machine shop does the removal and installation of the bearings
If a machine shop is pushing the bearings in along wth the ABS wheel, make sure the ABS wheel is measured first , the distance to the hub housing. Otherwise, the axle housing seal will leak
And bty, sometimes it's cheaper to buy the entire axle assembly rather than having a garage do it. You can buy a Dorman aftermarket with bearing's and abs ring installed
Used to be “Be Kind - Rewind.” for VHS tape.
With DIY repairs, it should be “Be Kind - Speed Up!” Time lapses are your friend.
Click on the screen while the video is playing and you can go into settings and change the playback speed of the video.
Is there any reason to not do the majority of the brake system disassembly/reassembly with the axle installed in the truck? Seemed to spend a lot of time chasing the assembly around while taking out and putting back in the brake parts. I'm an amateur so I'm probably just missing something here.
I’m wondering the same thing. It was secure on the truck and a lot easier to work on and not rolling around on the floor.
drums got threaded holes drive in the bolts to remove the drum
Amigo necesito saber como se desarma o se saca el piñón abs más la tuerca o retenedor de punta eje mazda 2012 4x4 bt50
Did this end up leaking again? I couldn't see it clearly, but it looked like maybe the machine shop pressed the ABS tone ring a little too far onto the axle.
No issues
Hi good job did it make like a bearing noise at sertain speeds? Mine 40 to 50
super helpful, until you said "we took it to a machine shop because we don't have a press" insert large eye roll here
yea its the worst part. also pay like $50 or so I dont remember. you can do it yourself but when you spend couple hours and risk damaging bearings. Its not worth doing it ourself.
LMAO....
Right tools would of helped you this is why I do not take my vehicles to a mechanic shop anymore
Part changer not a mechanic