Great video! However, when I tried it, I encountered an error. When the Pixhawk is booted with the transmitter enabled, it does not respond to the pitch’s PWM signal for avoidance. Moreover, when the pitch’s PWM signal from the ultrasonic sensor is active, the transmitter doesn’t enable. It seems that only one active signal is accepted at startup, does it work like an interrupt signal? I’d appreciate your guidance.
Hello. I put the hc-sr04 sensor in front of the drone and I want it to avoid obstacles. I updated all the parameters by looking at the ardupilot site. But as soon as I start flying in loiter mode, it starts flying backwards (as if it detects an obstacle in front of it). How can I solve it (I didn't use arduino. only sensor).
hello which language extension you have used in pixhawk for coding and can we control throttle and yaw in pixhawk using this type of coding because i want to induce fault in one motor and then to compensate it on other five motors because i am working on hexacopter
Hello, I'm having some problems with the communication between a ESP32 and PixHawk4, I'm trying to send STATUSTEXT from the ESP32 to PixHawk and I can't get messages to be seen in the "Status" tab, I already configured everything as it supossed to be, Can somebody help me?
Can we use the same coding for the APM flight control board in the combination with the LiDAR sensor?
do you set any parameters when connecting the arduino to px4 using telem1 ?
What are the parameters change in mission planner,i upload the code but I am not getting any updated data in channels override values
Great video! However, when I tried it, I encountered an error. When the Pixhawk is booted with the transmitter enabled, it does not respond to the pitch’s PWM signal for avoidance. Moreover, when the pitch’s PWM signal from the ultrasonic sensor is active, the transmitter doesn’t enable. It seems that only one active signal is accepted at startup, does it work like an interrupt signal? I’d appreciate your guidance.
I'm having the same problem :/ did you find a solution?
Hello. I put the hc-sr04 sensor in front of the drone and I want it to avoid obstacles. I updated all the parameters by looking at the ardupilot site. But as soon as I start flying in loiter mode, it starts flying backwards (as if it detects an obstacle in front of it). How can I solve it (I didn't use arduino. only sensor).
Can I use the same code and parameters for a rover??
Can you please tell the connection of receiver and Arduino
What about left and right
You are really intelligent 😮
hello which language extension you have used in pixhawk for coding
and can we control throttle and yaw in pixhawk using this type of coding
because i want to induce fault in one motor and then to compensate it on other five motors because i am working on hexacopter
Hey did it work for you to control throttle ?
Show the construction of your drone please
Can i use naze32 FC???
No. This works with ardupilot only.
your code does not work, pixhawk do not receive anything although arduino had sent
I want to learn... Programing drone.... Please guide me
Very nice presentation...
is that arduino uno R3 ooard ? sry i'am newbie in this hobby
SERIAL1_PROTOCOL?
Great work.. can I get this project sir???
Bhai g Apm ka sath Mera pas pixhack nahi hai
Apm may bhi same hai, apko telemetry port ka dekhna hoga bas !
Malayali❤
great work
🚀🚀
Hello, I'm having some problems with the communication between a ESP32 and PixHawk4, I'm trying to send STATUSTEXT from the ESP32 to PixHawk and
I can't get messages to be seen in the "Status" tab, I already configured everything as it supossed to be, Can somebody help me?
Impressive
Great work
Woah🔥🔥🔥
aga subtitles
Niice work