DIY Recoil Cord Replacement Honda Eu2000i
HTML-код
- Опубликовано: 27 дек 2016
- This video deals with replacing the recoil cord on a honda eu2000i generator. However to actually remove the recoil housing you need to remove the outside plastic covers and remove the fuel tank to get to this position. removing the plastics is the hardest job. if your cord has broke and need to install a new rope you'll have to wind the recoil perhaps 5 turns and adjust your rope as needed to fit the recoil as it unwinds. do not try to dissemble the spring to replace the rope as you may end up with a shit show.
Honda eu2000i diy recoil cord replacement
Cameras used in My videos
Olympus TG-Tracker amzn.to/2dYKLZr
Sony A6000 amzn.to/1ROrgJl
TG-860 amzn.to/1VU6vzP
DJI Osmo amzn.to/1QDjGFb
Drift Hd Ghost amzn.to/1UUiZZU
SJ4000 amzn.to/2bel0jt
Vidi Action Camera amzn.to/1SaLBtu
Sound effects by Epidemic Sound
epidemicsound.com
Royalty-free music by Epidemic Sound
epidemicsound.com Авто/Мото
Great video to demonstrate how to bumble your way through the simplest part of replacing the pull cord. The hardest part is getting the covers off and getting to the recoil unit, I can only imagine how well you handled that. 4 1/2 minutes of my life I can't get back... Watch the other video on pull cord replacement that shows the whole process and don't waste your time here
if you melt the ends it really helps in the feeding through the housing.
nice figure 8 knot.
i always take them apart and clean the spring and put a little oil on the spring. to keep the rust down. and to see if anything is broken or needs to be replaced.
i do like the idea of a zip tie.
good video Jerry.
How were you planning on feeding the handle through the cover? Shouldn’t you have put the string through the case first then tie the handle on
Great Collection of videos Jerry. Thanks for posting.
+1 on that can be a PITA job! Great vid man!
Wondering as to the original position.. as in when set up does the rope come out from the 4oclock position or the 6oclock?
I have 2 large generators that are electric start. Replacing the battery's is a pain for both so this is not so bad.
Excellent video, thanks!
I have a Honda EU20i ? Is the process and repair the same?
Well how do you now put the end with the pull handle through the hole on the side plate. I think you got that part wrong just saying
Where i get the recoil rope from and how much is it..? ty..!
How long is the cord? I think I made mine too short.
great, excellent, wonderfull
me and working with springs under pressure dont mix well, before I got my trade I went to replace a coil spring on my civic and I used the shitty 2 piece compressors from princess auto. For one they didnt fit my particular spring right so I should have stopped there but being an idiot I continued to compress it with a few wrench turns at a time on each side...I then thought this was too slow and put the impact gun on it and in the blink of an eye one compressor was embedded into my garage wall, one on the other side of the garage and the spring ended up under the bench...Turned white as a ghost and got sick I had to go sit down I got that much of a scare haha
Them springs will take your eyes out.
i've had bad luck with them in the past
jerry bskorner kind of like that Christmas movie ...Christmas Story ..You'll shoot your eye out
Why does everyone feed the cord in that direction ?
Feed cord inside to outside . Much easier