Great job, Your video was not too long, I bought a used x max, and I too was going through it. That way, I know what what's needed. You know what is new, Motor bearings are OK, but still need to be replaced. Gonna do that this weekend.😊
My motor shaft is pulling out while running my car and my pinion stays on the shaft, just walks off the spur. Do I need to replace a bearing or something or is it shot ?
Not to sure, you may need to take it apart and inspect. I replace the bearings in my motors annually and sometimes sooner depending on condition. Thanks for watching. Cheers 👍🇨🇦🤠
Just opened up my x maxx motor, found that there is a fishing wire type thing on the inside magnet piece that appears to be torn up. Do you know how I can get it replaced?
If the yellow kevlar coating is tore up, you will probably need to buy a new motor. Bearings going bad usually cause this to happen. You can try cutting the loose pieces off and see if you can get a few more runs out of it. 🤷♂️ Thanks for watching. Cheers
Great video 👍
Great job, Your video was not too long, I bought a used x max, and I too was going through it. That way, I know what what's needed. You know what is new, Motor bearings are OK, but still need to be replaced. Gonna do that this weekend.😊
Really appreciate the video was worried about doing this to my xmax but you make it seem simple enough
Sorry i didn't finish what I was saying can someone tell me why my motor hesitates when i full throttle it it hesitates then goes
Have you taken the motor apart, check the bearings and internal condition?
Had a problem with the shaft breaking the cover and coming through during assembly, any advice?
I'm not too sure what happened there. If assembled as per instructions, should go together no problem. 🤷♂️
My motor shaft is pulling out while running my car and my pinion stays on the shaft, just walks off the spur. Do I need to replace a bearing or something or is it shot ?
Not to sure, you may need to take it apart and inspect. I replace the bearings in my motors annually and sometimes sooner depending on condition.
Thanks for watching.
Cheers 👍🇨🇦🤠
Just opened up my x maxx motor, found that there is a fishing wire type thing on the inside magnet piece that appears to be torn up. Do you know how I can get it replaced?
If the yellow kevlar coating is tore up, you will probably need to buy a new motor. Bearings going bad usually cause this to happen. You can try cutting the loose pieces off and see if you can get a few more runs out of it. 🤷♂️
Thanks for watching.
Cheers
Awesome video! Do you know where I can purchase just the magnet ?
Unfortunately not sold separately yet anyway. Thanks for watching. 👍
@@markkumollari43 Thank you
Goit the 1275 1200v motor rebuild kit doesnt fit?
I have put the kit into 1600kv and 1275kv VXL motors. Look at the rear bell end of the motor, it had will have the motor size on it.
I'm guessing this is why my motor is overheating quickly.
Can someone tell me why my motor hesitates when i full
Get some better bearings asap TRB RACING 15$ completely saves the motor rotor from damage
part numbers for those trb bearings?. Please and Thankyou