I had to do this. Wasn't hard. Thankfully I had a really good picture of the completed wiring using the original 4 pin wires that came installed. Just had to remove three ground wires.
@@diyretroarcade hey brotha awesome video on how to test! i think he was asking what were the exact colors for them cause i also have a sanwa joystick and im building my own arcade cabinet for the first time and i wanted to see what the colors were to kinda get them going properly in the respective ipac board. I'm sure you might not recall cause it was a long time ago but if you do let me know! much love and thanks
I had to do this. Wasn't hard. Thankfully I had a really good picture of the completed wiring using the original 4 pin wires that came installed. Just had to remove three ground wires.
When I used the harness purchased from your site with new jlfs sticks they all end up with the same input. I can't figure out why
Then you are using the incorrect cable or its clocked wrong. Contact live chat and we can get you fixed up!
Thanks for the video. I have the exact same setup. So we are cutting a total of 3 unneeded ground wires?
you only need 1 ground for sanwa joysticks.
What about left and right ?
all the same method.
@@diyretroarcade hey brotha awesome video on how to test! i think he was asking what were the exact colors for them cause i also have a sanwa joystick and im building my own arcade cabinet for the first time and i wanted to see what the colors were to kinda get them going properly in the respective ipac board. I'm sure you might not recall cause it was a long time ago but if you do let me know! much love and thanks