Any problems with heat soak? Mine seems to loose a lot of power at around 80mph from doing a pull.. I hear a fans turning on also… any ideas of what it can be. All I have done Is have intake and a muffler delete. My best 1/4 on the dragy is 14.3
None at all. Datalogs show intake air temps actually going down at upper rpms. Cooling is great. Id datalog your setup if you want to find out whats going on. Common failure is the low temp cooling pump relay. Easy fix
@@mannyg-tech7063 unfortunately only a soft code. Youll never know otherwise which is scary because driving the car in anger with a non operational turbo cooling pump is extremely hard on the engine
@@electrox5473 if you run too aggressive of a map it just throws a code and gives you limp mode. Then you just clear it and its all good. Or you just run map 1 an never an issue. The beauty of jb4 is you just remove it before service or warranty work. Even at the side of the road. Its very easy.
I have a squadra tune sitting on my desk, have yet to install it. It advertises that it raises the limiter to 168 from 150.
Any problems with heat soak? Mine seems to loose a lot of power at around 80mph from doing a pull.. I hear a fans turning on also… any ideas of what it can be. All I have done Is have intake and a muffler delete. My best 1/4 on the dragy is 14.3
None at all. Datalogs show intake air temps actually going down at upper rpms. Cooling is great. Id datalog your setup if you want to find out whats going on.
Common failure is the low temp cooling pump relay. Easy fix
Hmm that’s odd. My 2017 TI was built in May and doesn’t do that, I get pretty consistent times with my dragy.
Do yo I have any problems with heat soak? For some reason after doing a pull mine seems to loose power at about 80mph and fans cut on.
Check your low temp cooling pump relay. Known issue
@@bhvrdr thank you brother! But won’t that trigger a code?
@@mannyg-tech7063 unfortunately only a soft code. Youll never know otherwise which is scary because driving the car in anger with a non operational turbo cooling pump is extremely hard on the engine
@@bhvrdr thank you brother, I will look into it. What what can I use to data log? Jb4 ?
Is this map 1 or 2 ?
Map 1
Any mods?! ...Is this the AWD or RWD?
Just jb4. Its rwd
@@bhvrdr has the jb4 caused you any issues or thrown any codes? I'm thinking about getting it for my car but I'm worried about voiding my warranty
@@electrox5473 if you run too aggressive of a map it just throws a code and gives you limp mode. Then you just clear it and its all good. Or you just run map 1 an never an issue. The beauty of jb4 is you just remove it before service or warranty work. Even at the side of the road. Its very easy.
Veloce is AWD, no ?!
@@_Atomic_impact not in the usa. We only get the 280hp engine choice and can choose either rwd or awd
any tunning on power?
Jb4 gives about 30hp
@@bhvrdr do you recommend JB4? I plan to purchase all my parts from the EuroCompulsion site, any differences?
@@reftwong7968 they're ok too but you do have to flash your ecu with them so your warranty is likely impacted. Same power increase though.