Epson EcoTank 1810 (converted to Sublimation printer) Unboxing, Set Up and First Use

Join me for this unboxing, set up and first use of the Epson EcoTank 1810 (converted to Sublimation Ink)
I used SILHOUETTE STUDIO to print from.
The printer package I purchased is available here
skatkatz.com.a...
The square coasters I used are available here
skatkatz.com.a...
The design from Creative Fabrica is available here
www.creativefa...
The Epson website for setting up the printer is here
www.epson.com.au/
Thanks for watching!!!

[@cinnabar546]

well done!! thank you! I jsut got mine from Officeworks and it's an Epson so it's notoriously hard to setup but it's a robust product

[@axonis2306]

Just be sure to print a nozzle check every 3-4 days. While turned off, give the printer a light shake every week. Pigmented inks tend to settle and that causes clogs.

[@tanyamihe633]

Thank you for making this video. I always wondered what the setup would involve and now I know.

[@deniseroberts5132]

Thank you for making it so easy to understand 🥰

[@JevoneeIRhea]

Did you include what side to feed into the printer

[@anjunadevi1091]

Thank you for this video

[@brella96]

What settings on the printer did you use for silhouette studio?

[@liliananegoita9828]

Hi! I would like to buy this sublimation printer, but I would like a recommendation on how it works, if it is a good brand, if it produces high-quality prints, if it doesn't break after a few uses...what can you recommend? Is it worth the investment or should I look for another model? Thank you!

[@TheMeninnaaa]

Could this printer be converted to DTF aswell? Plss i need to know...

[@lionbarlover]

How do I print the sheet with the password on it?

[@Skye-uu2dn]

So the way you convert the printer, is putting in the sublimation ink in the tanks, is that correct?

[@skat_katz]

Hi Skye, for NEW printers, yes, it’s as easy as using sublimation inks right from the start. If a printer has already had standard inks installed then its not quite so easy and the ink tanks, lines and pads all need to be flushed clean before you can install sub inks for sublimation.

[@ValyArdeleanu]

@@skat_katz you don't need to flush, do multiple prints. ( like 12-14 nozzle checks)

[@pinsan5817]

Hi i have a problem. There is no light on the ink logo. 🩸 like that. I still perform the "Charging ink". When i try to print a nozzle check pattern,there was no ink comming out. No ink on the paper

[@pinsan5817]

PLEASE HEYLP😢