Hello i am doing a bearing job on a w575h electrolux front load washer. I got the new bearings in the housing and seals but when i tighten the housing back on the drum does not spin. Would you have some clues on what it could be? I double checked bearings and they are pressed in right.
Hello i am doing a bearing job on a w575h electrolux front load washer. I got the new bearings in the housing and seals but when i tighten the housing back on the drum does not spin. Would you have some clues on what it could be? I double checked bearings and they are pressed in right.
Thank you for the content!
What do you do when there are no jack holes (like on the old 18 lbs unimac washer’s)?
a doubt dear friend, I follow your videos, the position of the seal the spring is up or down in the housin?, since it is not clearly seen in the video
Spring towards back of washer. The sealing flatter side without a spring showing faces the front of the washer where water comes in.