At 7:44, it's out of order. You can't put the pin in before the trigger housing. Wiggling in the takedown bar while holding down the spring is tricky. Mind lining up the notch on the bar to the frame, going in from the left, the notched part going in last.
I wish the view was closer to the takedown of the slide and voice audio would be helpful. I’m trying to take down my slide completely to send it in otherwise I will be charged. Hopefully I can figure it out
At 7:44, it's out of order. You can't put the pin in before the trigger housing. Wiggling in the takedown bar while holding down the spring is tricky. Mind lining up the notch on the bar to the frame, going in from the left, the notched part going in last.
I wish the view was closer to the takedown of the slide and voice audio would be helpful. I’m trying to take down my slide completely to send it in otherwise I will be charged. Hopefully I can figure it out
I really like the pps
Great job! Keep it up 👍
Why would you need to remove the front sight unless it was to install a different one?
you kinda answered your question there.
Good think you didn't disassemble the trigger group. That's a bitch to get back together.
Why did you remove the voice over? If I recall this is a bitch to reassemble thanks to the weird backstrap system.