How To Test The TPS (1997, 1998, 1999, 2000, 2001 2.0L Honda CR-V)
HTML-код
- Опубликовано: 9 июл 2024
- How To Test The Throttle Position Sensor (TPS) On The 1997, 1998, 1999, 2000, 2001 2.0L Honda CR-V.
Free troubleshooting guide here: easyautodiagnostics.com/honda... 
Авто/Мото
Great video, thank you. Didn't help my problem but helped the know how. Thanks you.
amazing video . very easy to follow . thanks
Great content great video different than every other video 👍
Very good vlogger step by step instruction think you for all
Good vlogger good tutorial think for lot of knowledge
Very Nice easy step by step guide... Thank you!
WELL DONE SIR!
Buen trabajo amigo saludo bendicione 💪 🤝 👍 💯
thanks very much
Perfect thank you
Thank you
Thanks !
Teşekkürler .
Thank you for your video. Good quality content. Could the test(s) be effective on a 1997 Honda Accord?
Thanks
Great 👌. I learned from your instructions. More to come. Thanks
Ok update the power voltage I have is 7.20 volts and my ground is 15.20 on the connector without being connected to tps any idea why my ground and power to tps is not accurate?
How do I know which wire to back probe? In your case, pink color of the wire is pink
My 5v wire reads 5v
Ground reads 11.5v tps does not hit 4.5 brand new tps can it be a faulty one being new
Im getting 0.50 at closed and 4.25 at wot. Any help? 1998 Civic EX 1.6 Liter
excelente aporte
What if i get a reading of 1.2v instead 0.5v? That's the lowest I could adjust my sensor. Is my TPS failing?
Hi Sir. Can share a test Toyota throttle body ?
please in first test how connect red with black why you not connect them directly
Tps sensor is good but when tps sensor plug engin slow what damage in ecu
Did Honda change this part TPS in 2002?
I hope you can help me out.
Im getting code p0122 constantly after 3 tps already.
Ive done Everything in this video and it reads correctly.
I have even replaced the throttle body and it drive fine for 140 miles and then it started to give me issues with the transmission.
Thanks in advance.
My gosh, your positive battery terminal is so close to your intake pipe!
On my 2000 Honda Civic, I replaced the tps sensor but did not calibrate it and just bolted it on. I started the engine and got a check engine light and the code "p0122" which is circuit A low voltage. Does this mean at idle my volts are below .5? And does this code sound like an uncalibrated tps sensor? The actual tps sensor is also brand new btw.
did you solve it?
I am having the same problem
Did you solve it?
I was wondering if you could please help me out . I tested 3 different tps sensors and neither of them move when I move the throttle. I'm wondering does the ecu have anything to do with the signal coming out of the tps . Or does the tps send the signal on it's own. Its weird that I tested three of them and like I said neither move at all when I throttle it by hand. Please let me know.
Did you ever find out why?
@@brayanenrique2532 I ended up getting readings but I had a bad connection in my ecu which kept triggering a code .
Nice, But why check the variable DC before checking the 5 Volt supply,, I would start with the 5 Volt check, than proceed to the variable output.
Yes, you can start out by checking the 5 Volt supply. I personally have found that by checking the TP signal output first, I can immediately find out if the TP sensor isn't producing its variable voltage output. If the TP voltage signal is doing what it's supposed to do, I can forgo the other two tests and focus my diagnostic efforts elsewhere. This is just my workflow. There's no right or wrong way, as long as you reach the correct conclusion.
is my TPS defective always at 5.09 V both idle and full throttle?
Yes
If this the same for calibrating a tps
I am getting good power and ground but am not getting the correct signal voltage (middle blk red terminal) any help
If you're getting 5 Volts and Ground is present, but the TPS signal voltage is off, then the TPS is bad. Just out of curiosity, what is the TPS signal voltage you're getting at closed throttle and at open throttle?
@@tecman129what happens if you disconnect it and drive
I have 6.40 volts of volts is that bad ?isn't supposed to be 5.0 volts?
So the tps is getting power but 6.40 volts
you really need to use a scope to visualize the voltage ramp to see how well the TPS is tracking.
Good day my check light is stll coming on ofter about 15minutes of driving why is that?
And the code is 7
Rispekt
Honda crv 1999 arranca con falló por la mañana
Nada que ver ese auto viejo con el Accord del 2000 en adelante
Power is 5v
Reference is .5-4.5
Ground checks out 12.6
Why is it still throwing a TPS code
Replaced the sensor as well
What is the specific trouble code you're getting? Please post it here and I'll see what I can do to help you troubleshoot it. The trouble code number itself is a clue to what is happening.
Thank you so much for your help. My error code is 54-1 in a CRV
Wup bro got my Honda CR-V and today got thad code take aut map f car go off put back staring it stay on take put back tray got off thing need new one where can got good price check auto zone asking me $65 dollar to much thing thank you
B
What the code for thad got the 2000 ex 5 speed honda cr-v put the machine to see what code give me i got 2 code 1 position sensor intermittent interruption p1381 the 2 it Radon cylinder misfire Deteeted p1399 iam put new thistribudor oready thank let me now please you now driving it for like 30 m got parking it got staring on don't want stared way like 20 m it staring ogaing
My litgh for the motor coming on to
Very good vlogger step by step instruction think you for all