Unveiling RC Lidl Hunter Build - Complete Parts List!

Clear and easy step by step DIY build instructions to create this great looking Hunter style RC Lidl conversion. And sorry, didn't mention prop. 5040 2 bladed. 00:00 introduction 00:19 remove dihedral from wing 02:04 cut the wing sweep 03:55 cut the tail sweep 05:03 prep the fusi for wing fit 06:50 cut ailerons 09:43 tail and elevator 13:58 hollow out fusi 14:30 fit elevator servo 18:33 glue on main wing 20:18 paint job 20:49 fit motor 21:36 fit aileron servos 22:41 electronics installation 23:04 the lipo fit 23:08 lead in the tail 23:23 GO AND FLY!
parts:
BR1806 motor www.banggood.c...
prop. 5040 2 bladed.
12A ESC www.banggood.c...
Servos buy 4 here www.banggood.c...
FS2A receiver , suits FlySky tx etc. www.banggood.c...

[@James-gz4oj]

Excellent detailed vid on how you built the hunter
and with the components thank you 👍👍

[@bobflyman]

You're welcome mate! It's a long video and I tried to cover most things. Couldn't go into details about electronic side but there are plenty of vids around on that subject. 😉

[@carlhumphreys9024]

Nice build Bob. A few months ago, my nephew bought a plane like yours, he asked if I could turn it into a Rc plane, I said I wasn't sure until I ran across your video. He'll like the video. Thanks

[@bobflyman]

Great! Have a go, but I warn you, it's addictive! 😊

[@bobflyman]

A bit quick as a trainer though, you 'd probably be better with one of my other builds😮

[@CliffHarveyRCPlanes]

Love the hinge method and wire hiding Bob, top video 🙂

[@bobflyman]

Thanks Cliff. Burning holes though inside the wing for the aileron servo wire was very dodgy. Very nearly came through the wing. 😳 That would have been far easier before glueing the wings in 🤔. But you live and learn with a prototype build. 😉

[@lynnandrews5313]

That was a great video to watch. 👌

[@bobflyman]

Thanks, glad you enjoyed it!

[@Richard-leech727]

Just started a swept wing - not as swept as the Hunter, but certainly a few good ideas to emulate - how was the clear canopy done?

[@bobflyman]

Hi Richard, canopy? I just cut a suitable slice of clear plastic bottle and poured hot water over it to get a better curve. Then cut out the foam and glued that clear plastic bubble in to it. It's tricky to get it right. Takes a few fails! Some people use a hot air gun and make a plug of the shape they want. You can see how I made another one here ... ruclips.net/video/yYPP9JIE1So/видео.htmlsi=oNueMuh_yhvB2dRO

[@SalvationArmyWatcher]

And the propeller?

[@bobflyman]

sorry , 5040.

[@rosapalma9827]

Your content is one of the best in my opinion, very detailed, explanatory and fun to follow.😀👌👌

[@bobflyman]

Thanks. That's very kind of you. I'm glad you enjoyed it! 😁