How to Replace Garage Door Weather Strips

In this video Mark Donovan of homeadditionplus.com shows how to replace garage door weather strips. He provides step-by-step instructions on how to remove garage door weather strips, and how to install new garage door weather strips.

[@HomeAdditionPlus]

For more helpful videos like this please consider supporting my channel by either subscribing to it or giving a Super Thanks. Your support helps to enable me to both create more content and improve the quality of it, via the acquisition of new camera equipment, editing software and purchasing subscriptions to quality royalty-free music.

[@YouTubeCertified]

Excellent vid. Thank you very much

[@stevevlahos5469]

Thank you. Spring project coming up for me. 😊

[@BurtBowers]

These are sold at lowes but not in wood the rubber comes attached to vinyle molding which is good so they do not rott out though I am currious being vinyle when attaching them if it will look wavy from nail to nail?

[@olgapaulus7299]

Thanks for sharing!

[@kevinfromttt]

Great video thx ☺️

[@Hoojammyflip]

Thanks Mark 😁

[@ericsanoe3206]

Thanks for the nice video

[@janicehetrick8297]

Do you have a link of the materials that you used? The nails and seal? Thanks!

[@JJ4848]

What do you do if your side seal keeps ripping at the top? If i move it out anymore it will not cover enough

[@rea8755]

Thank you.
How does water wick up plastic?

[@HomeAdditionPlus]

It doesn't

[@johnb7346]

Did you buy new wood with the rubber seal pre-attached? All I can find is the rubber strips. Your material is how I want to do this job.

[@HomeAdditionPlus]

Yes i did. I think I got it at Lowes.

[@johnb7346]

Thx!

[@aaronvincent9003]

How did you glue the rubber seal to the new wood so nicely and regularity? What method and glue did you use?

[@benjamincurtis6711]

@@aaronvincent9003 it comes like that

[@davidnle]

the mouse bites off the bottom of the garage seal. Do you have a solution to fix just that part? thnks

[@HomeAdditionPlus]

I have a video on setting a mouse trap. Check that one out :)

[@BornAgainFaith]

Where do you purchase these?

[@HomeAdditionPlus]

Any large home improvement center.

[@yellow_panther]

1) removing my old weather strips was a BEAR. Contractor had used some super gripping nails and it was very hard to pull the strip off. 2) I'd recommend using stainless steel nails. My old strips were attached with galvanized nails and they were pretty rusted. 3) Why not paint the wood before installing the new strips?

[@donna-or6cl]

Replaced a new strip and now the door won’t go down completely. About 1/2” off. 03/04/23

[@prayerEwind]

Did you get your garage door to shut? I've seen the same issue. I'm guessing it's due to side strips being too close to the door causing too much friction. How did you fix the problem?

[@MrKenstar2]

Plastic doest wick up

[@texasstyle09]

What kind of nails did you use?

[@HomeAdditionPlus]

Its been awhile since I did that project, however, I pretty much exclusively stainless steel nails on exterior surfaces. I got fed up with galvanized nails rusting through after only a few years.

[@stealth418]

@@HomeAdditionPlus why not use screws?

[@terencemayhew2290]

No need for screws. You're holding trim not trusses. Lol. And he mentioned 8d galvanized nails. I believe.

[@yellow_panther]

I used SS finishing nails on a Ryobi P326 nail gun. Worked great.

[@Keashane]

Why don’t u use a screw ?