When I did my air, I ran the line thru a rubber tubing that has a ID that matches the OD of the airlift tubing. Particularly for areas that may experience chafing or wear... Just as a precaution. Been running my setup for 6 years with zero leak issues.
So my one question is if you are able to have multiple air settings. The resting "to the ground"; regular daily driving; and then if you have a good in-between, like if you were doing a quarter mile run or something like that.
Got Airlift 3p about a week and a half ago, dropped my car off at SlammedEnuff to get it installed by the pros. I’m so anxious and can not wait to get my car back🤙🏼🤙🏼 wanted air since I was 16
@@quindariousgooch1962 I sold the car in November, I loved it. Had a leader line break, other than that it was good. SE did an okay job of install. Not perfect but it worked
I have one question, whenever I go to a website such as airlift performance I never see the air tank listed with any of the available purchases. Do I need to get it from someplace else? Plz help
I don't know what kind of car you have but I drive a 2013 Camaro 2SS . It's trunk is not that spacious. I have a 5 gal tank , two compressors , two ancient crossfire amps and two separate side boxes holding 10"subs. I still have room for the spare tire and battery (granted they are tucked away in the stock hidden compartment. It doesn't take up too much space. I can still put groceries in the car.
you know what else is about 4000 dollars mint? An NX2000 or a B13 Sentra SE-R I really think the best choice now is to make a video about this. I have literally been asking for this every single day since October 28.
I would double check all the locking collars on the strut and if everything is tight you may need to reuse rubber pieces if your car had them factory for noise reduction. Hard to diagnose without hearing it in person. Hope that helps! - Jt
@ Dakota - you're in a cold weather state (WI) like me (RI). I saw yall talk about the durability of AL's bags from an abrasion POV. What's your opinion on the longevity of the bags/system dealing w/ the extreme weather diff. (hot/cold) we both go through?
As long as you pay attention to your water trap you should be completely fine! Dakota has had no issues with his bags in over 2 years of Wisconsin weather!
Difference is the ride height management system. 3S is the cheapest. 3P has sensors for pressure and 3H has sensor for the actual ride height of the vehicle
Well, you've got struts, pump, manifold, tank, lines, harnesses, fittings, misc pieces and the controller. Then there's all the time to R&D the system, develop instructions and create an app. Then you've got the DFM engineering for production and packaging. Then there's shipping/distribution, warehousing, customer and parts support and establishing a vendor network.
@@dolamyte I got that. Perhaps it's different for every car. For My MR2 a 3H complete package caps out at $3,800 and you get all those things. So I was a bit surprised to see a 3P for 4,900.
@@aphromew4502 Every car is different and will need different equipment. The struts for your MR2 won't work on my mk7.5 GTI. There's also market demand for each platform and where their economies of scale are at. Struts for mine might be more expensive to manufacture but could be similar in the price we pay simply because there's more GTIs than MR2s getting bagged. Market share and volume will also affect price since the more you can manufacture, the lower the per item cost will be.
![Young Nudy - John Wayne (feat. Metro Boomin) [Official Video]](http://i.ytimg.com/vi/NY8HnYYo2fo/mqdefault.jpg)
Check out Airlift here!:
bit.ly/347p68J
I can't wait for my wheels to show so I can send in my baby on airlift 3h to get reviewed by Dakota just you wait for spring its gonna be spicy town.
Day 45 asking fitment industries to do episode on so you want a lotus exige s.
I just got the 3p kit installed on my Camaro vid dropping in a week!
So no one is going to talk about how Dakota just erased that paper out of existance? 3:29
The music said enough
I was reading this as it happened 👀
Also, I've said this before and I'll say it again. Air ride is durable. We semi trucks have been running it for ages.
When I did my air, I ran the line thru a rubber tubing that has a ID that matches the OD of the airlift tubing. Particularly for areas that may experience chafing or wear... Just as a precaution. Been running my setup for 6 years with zero leak issues.
Sometimes I take a taco from Taco Bell & eat it.
Nice
@@muuli600 nacho del grande in my mouth if you know what I mean ... I'm eating chips.
Bruh what 🤣🤣🤣
Nice
good on ya
3:25 that paper is on its way to bobby shmurdas hat right about now.
Fred the fish My Leg!!!!
So you want a DONK
North Dakota got the holiday, clean up for family, fade going on!
So my one question is if you are able to have multiple air settings. The resting "to the ground"; regular daily driving; and then if you have a good in-between, like if you were doing a quarter mile run or something like that.
I can appreciate the air suspension, but when it costs 1/3 of my car I think I'll stick to my coilovers.
Air on mine would cost more than my entire car😂😂
Nice video!...But the question is how does air perform in harsh winter climates?
Great video!
Can you guys do a review video on a car with this kit installed? I've been thinking to get this kit for my Lexus RC, thanks 👌
Got my full setup from a parts plug new for 2600 and had it installed for 500.
Damn, you took that excitement of opening packages away from him lol
Hay with the lines, is it possible to run them behind the side skirts?
Oh man you guys are killing me. I need stuff for my work truck but then my brain is like "BuY aIr SuspEnSiOn RiGhT nOw.".
Cant wait to get my air suspension!
can't wait to finaly get a Car to put air suspension on
(so u want e46)
Can y’all make artisa wheels in viper spec?
Cool vid bud
Can you review other brands of coilovers, like airone coilovers from Malaysia
Got Airlift 3p about a week and a half ago, dropped my car off at SlammedEnuff to get it installed by the pros. I’m so anxious and can not wait to get my car back🤙🏼🤙🏼 wanted air since I was 16
How are you liking it a year in and how much did it cost for the install? I just got mine and am looking to bring it to slammedenuff as well
@@quindariousgooch1962 I sold the car in November, I loved it. Had a leader line break, other than that it was good. SE did an okay job of install. Not perfect but it worked
You ran bags on your 9th gen coupe?
@@marcosmerced7400 I did
I have one question, whenever I go to a website such as airlift performance I never see the air tank listed with any of the available purchases. Do I need to get it from someplace else? Plz help
Is the front and rear sold separately
I keep thinking about going air. Only thing I fight myself about is the storage for the tank & compressor...
I don't know what kind of car you have but I drive a 2013 Camaro 2SS . It's trunk is not that spacious. I have a 5 gal tank , two compressors , two ancient crossfire amps and two separate side boxes holding 10"subs. I still have room for the spare tire and battery (granted they are tucked away in the stock hidden compartment. It doesn't take up too much space. I can still put groceries in the car.
I would like to see the cete air management for Audi. Not innie
But would u run air in the winter
you know what else is about 4000 dollars mint?
An NX2000 or a B13 Sentra SE-R I really think the best choice now is to make a video about this. I have literally been asking for this every single day since October 28.
Can you air lift a z31?
“So you want a Ford Taurus SHO “ 1st and 2nd gen (the real sho)
So I want b13/b15 nissan sentra SER/SER SpecV
Cool video can you guys recommend a good solution for the clonking noise coming from my top hat on my 3H performance front strut.. please lol thanks
I would double check all the locking collars on the strut and if everything is tight you may need to reuse rubber pieces if your car had them factory for noise reduction. Hard to diagnose without hearing it in person. Hope that helps! - Jt
@@FitmentIndustries I have the adjustable camber plate hats I tried putting adhesive foam on top but no good...
Has the paper finished falling down yet?
@ Dakota - you're in a cold weather state (WI) like me (RI). I saw yall talk about the durability of AL's bags from an abrasion POV.
What's your opinion on the longevity of the bags/system dealing w/ the extreme weather diff. (hot/cold) we both go through?
As long as you pay attention to your water trap you should be completely fine! Dakota has had no issues with his bags in over 2 years of Wisconsin weather!
Day 28 of asking for "So You Want a Cadillac CTS V"
Whats the difference between those are struts and D2 air struts? Which do you prefer?
Airtekk
The bottom of the tank is definitely not where the air dumps from... it dumps from the valves.
Numero 8
Day 11 of asking for “So you want an E28 BMW”
Make a video of airtekk
So you want a z31 300zx?♯40
Need more static
Super or turbocharger setup and why
Supercharged because that’s what I bought already
what kind can i use for a 2006 pacifica ?? no one has them
Might have to go with a custom setup! Universal air is someone I’d contact to see if they can do it. -Edgar
Day 45 asking fitment industries to do episode on so you want a lotus exige s.
Nice hair cut 😳
Its said that paper joined SpaceX
Who doesnt love air suspension 💎👑🔥
Nissan Y-Chassis
‘So you want a Ford zx2 with a $4000 air suspension’
3H, 3P and 3S what is the difference?
Difference is the ride height management system. 3S is the cheapest. 3P has sensors for pressure and 3H has sensor for the actual ride height of the vehicle
@@DuncanL7979 thank you very much.
I wish I could afford it lol, next year
SAVE DAT MONEY!!!
@@FitmentIndustries fr, once summer hits the Stang is getting slammed
I'm so fast I didn't even watch the full video
😂
Static is the only way to go, bags are for groceries 🛒
Day 5 of asking for So you want Renault Megane R.S
Day 12 of asking for "So You Want a Acura TSX"
why is it 4,900?
Well, you've got struts, pump, manifold, tank, lines, harnesses, fittings, misc pieces and the controller. Then there's all the time to R&D the system, develop instructions and create an app. Then you've got the DFM engineering for production and packaging. Then there's shipping/distribution, warehousing, customer and parts support and establishing a vendor network.
@@dolamyte I got that. Perhaps it's different for every car. For My MR2 a 3H complete package caps out at $3,800 and you get all those things. So I was a bit surprised to see a 3P for 4,900.
@@aphromew4502 Every car is different and will need different equipment. The struts for your MR2 won't work on my mk7.5 GTI. There's also market demand for each platform and where their economies of scale are at. Struts for mine might be more expensive to manufacture but could be similar in the price we pay simply because there's more GTIs than MR2s getting bagged. Market share and volume will also affect price since the more you can manufacture, the lower the per item cost will be.
562st
🌽🍞
Day 15
So you want a kei truck
DAY 18 OF SO YOU WANT A PONTIAC AZTEC
Day 123 of asking for "So you want a Kei Truck". . . 🚛💨
Day 17 of asking for a roasting a integra gsr owner
Day 1 of so you want a volkswagen bus
Naw, this is built motor $.
day 14 of so you want a Honda Fit
Day 24 of So You Want a Polaris Slingshot
Sometimes I take a taco from Taco Bell & eat it.