CENTERING the MILLING TABLE in a few seconds
HTML-код
- Опубликовано: 15 сен 2024
- If you do not have an indicator dial or you are in hurry, you can center the ROTARY TABLE on the milling machine with a very simple tool. There is not much to turn on the lathe.
Nice I think you foregot to click the collet into the holder correctly. Then try again for run out
yeah he didn't snap the collet into the nut and then insert it into the holder
Yes, I was more concerned with the video and really forgot to tighten properly. After reading your message, I went to the workshop and redid the measurement and to my surprise the deviation is below 0,02 mm. Thank you very much for noticing this and sending it to me !
Your are right ! Unfortunately, I was more concerned with filming and forgot this. Now , the deviation is below 0.02 mm. Thank you for your message and for your time !
Olá amigo trabalho bastante interessante!!!
Boa sorte sempre!!!
I am honored, my friend !! Good luck too and thank you very much !!