HOW TO REMOVE AND REPLACE AN ANGLE VALVE REMOVING THE COMPRESSION RING WITH AN OLIVE PULLER.
HTML-код
- Опубликовано: 27 авг 2021
- In this video I will show you how to remove and replace and angle valve.
I will remove the compression ring with and olive puller.
olive pullerwww.amazon.com/GOGOLO-Remove-...
Thanks!
good job Alex 😎👍
Great Video. Thank you for sharing
Thank for the tip brother
Excellent! Thank you!
Thank you!!
Great video 👍. Thank you
Thank you
I was about to run and grab one of these at Home Depot (they call it "sleeve puller") but I tried putting the old fitting back on loosely, and wiggled it a bit while pulling. It worked!
Thank you very much for taking the time to make this video. I wanted to ask you how much do you have to turn for the final tightening of the nut. Is it a quarter turn or a half turn.
Hello Richard,
The old angle valve nut to the tool? You want at least a couple turns so it has a good grab. When you turn the tool handle, it is pulling the valve nut, bringing the sleeve at the same time.
I hope this answer your question. Thanks so much for subscribing.
Sorry,
I wanted to ask for tightening the nut with ferrule to the new angle stop. How many revolutions or turns are needed. Thanks
@@richardl341
Hello Richard as hard as you can.
All the way. tight! ( just using hand wrenches) AS you tighten it is going to compress the sleeve and make a positive seal. If is loose it will leak or the water pressure will pop it out. Thanks
Wow! Excellent, what is the name of this tool?
Hola Roman I just place the amazon link where to buy it in the description of this video.. Just so you know I have a channel in Spanish. It is called "Alex the handyman en Español:"
wow! Excellent, what is the name of this tool?
Olive extractor
This tool you used is listed on amazon as being 15mm to 22mm is that the correct tool for this half inch copper pipe and fitting? need to know before I purchase it if it will fit all my standard sink and toilet valves I need to replace. thanks
Hello Muddywater. Yes the 15mm is for 1/2 in
and the 22 for 3/4. Let me know how it goes. Please don't forget to subscribe if you haven't.
@@alexthehandyman3494 For 1/2" U.S. valve threads mine are 12 mm. 15mm does not work.
@@ramonestrada38
Hello Ramon In US most sink, vanities and toilets supply lines are 1/2 copper,
This tool is only for 1/2 and 3/4 copper pipes.
Imperial sizes are measured using the approximated bore diameter, for instance the outside diameter of 1/2 copper is about 15mm and 3/4 is about 22mm. Let me know how it goes.
@@alexthehandyman3494Yes thank you it works great.
Bumbling stumbling
Hello Mr George, he's not a good operator