MAN, YOUR FOCUS IS CLEAN! I HAD A PONTIAC GRAND AM THAT HAD NEVER SEEN A FOOT ON ITS CARPETS! THE ORIGINAL OWNER INSTALLED CARPET OVER THE ORIGINAL THEN,CLEAR PLASTIC MATS W/SPIKES ONTOP OF THAT, THEN FLOOR MATS! SO, I CONTINUED THAT & ADDED ALOT TO THAT CAR! CUSTOM STERIO W/40 WATTS TO EACH SPEAKER & 2 KICKER ZR240 AMPS ON TWO 12"S WITH 2ND BATTERY< 1 FAROD CAPASITOR & 7VOLT LINE DRIVER ALL POWER WIRES RAN W/RELAYS FOR PROTECTION! NEONS INSIDE & OUT. CUSTOM DROPPED SUSPENTION & WHEELS, REMOTE START & ALARM & ALOT MORE! STERIO HIT 146.8 DECIBLES IN THE 90'S NOW, I DRIVE A 03 FOCUS & I HAVE UPGRADED EVERY PART ON THE CAR!!! TODAY, I CHANGED ALL THE MAIN & ROD BEARINGS! ALL BUT MY #3 MAIN?THRUST BEARING IS GIVING ME A PROBLEM COMING/ROLLING OUT, IM DOING THE WORK FROM UNDER THE CAR, IN THE COLD_EAST COAST WINTER, I WISH MY FOCUD WAS A NEWER RS!!! I HAVE DROPPED ALOT OF $$$ INTO THIS CAR ALREADY! FAR EXCEEDING ITS VALUE & WHAT I WOULD EVER GET OUT OF IT! SO I MUST DRIVE IT FOR MANY YEARS TO COME TO RECOOP THE $$$!!! THIS SUMMER I WILL REBUILD THE MOTOR MYSELF & PORT & POLISH & THE HEAD, DOUBLING ITS FLOW & INSTALL AFTERMARKET RACE CAMSHAFTS & HOPEFULLY A TURBO SET UP & RUN LOW BOOST UNTILL I CAN AFFORD A WIDE BAND & ECU + TUNE.
Great video man, only suggestion I have is that if you don't want to use the double sided tape you can use Velcro. I used Velcro and it holds very well.
I don't think there's footrest in Focus equipped with Auto Transmission too...or at least in the US-Spec Focus (We've always gotten water-down version in any Global model).
Thanks! I'll switch to Velcro too if the original d-tape on this aftermarket footrest couldn't take my abuse. :) Feel free to share my videos and your ideas!
Mostly because of Cost and Space in that firewall area. You can still tape something there to avoid staining the carpet when your left foot is not actively engaging the clutch pedal.
If you take it off, don't pull on it. Take a sharp knife and kind of cut the space between the tape and the carpet to keep from pulling all the fibers out.
I'm sorry but this video is terrible. It is much better to buy a small package of 3m velcro and only use the rough side. Cut it into strips and place around perimeter of back of dead pedal and then stick the velcro right to the carpet. Then you can remove it any time you want and you can also clean it easily.
...and that dead pedal is $7 on ebay now. It is terribly cheap and the treads will push in. the metal is very flexible. If you want a good deal on a real one get the Steeda aluminum piece.
![Blox Fruits Dragon Rework Update [Full Stream]](http://i.ytimg.com/vi/EqDAp8udhm0/mqdefault.jpg)
MAN, YOUR FOCUS IS CLEAN! I HAD A PONTIAC GRAND AM THAT HAD NEVER SEEN A FOOT ON ITS CARPETS! THE ORIGINAL OWNER INSTALLED CARPET OVER THE ORIGINAL THEN,CLEAR PLASTIC MATS W/SPIKES ONTOP OF THAT, THEN FLOOR MATS! SO, I CONTINUED THAT & ADDED ALOT TO THAT CAR! CUSTOM STERIO W/40 WATTS TO EACH SPEAKER & 2 KICKER ZR240 AMPS ON TWO 12"S WITH 2ND BATTERY< 1 FAROD CAPASITOR & 7VOLT LINE DRIVER ALL POWER WIRES RAN W/RELAYS FOR PROTECTION! NEONS INSIDE & OUT. CUSTOM DROPPED SUSPENTION & WHEELS, REMOTE START & ALARM & ALOT MORE! STERIO HIT 146.8 DECIBLES IN THE 90'S NOW, I DRIVE A 03 FOCUS & I HAVE UPGRADED EVERY PART ON THE CAR!!! TODAY, I CHANGED ALL THE MAIN & ROD BEARINGS! ALL BUT MY #3 MAIN?THRUST BEARING IS GIVING ME A PROBLEM COMING/ROLLING OUT, IM DOING THE WORK FROM UNDER THE CAR, IN THE COLD_EAST COAST WINTER, I WISH MY FOCUD WAS A NEWER RS!!! I HAVE DROPPED ALOT OF $$$ INTO THIS CAR ALREADY! FAR EXCEEDING ITS VALUE & WHAT I WOULD EVER GET OUT OF IT! SO I MUST DRIVE IT FOR MANY YEARS TO COME TO RECOOP THE $$$!!! THIS SUMMER I WILL REBUILD THE MOTOR MYSELF & PORT & POLISH & THE HEAD, DOUBLING ITS FLOW & INSTALL AFTERMARKET RACE CAMSHAFTS & HOPEFULLY A TURBO SET UP & RUN LOW BOOST UNTILL I CAN AFFORD A WIDE BAND & ECU + TUNE.
Sounds like an interesting project car, enjoy the build!
Great video man, only suggestion I have is that if you don't want to use the double sided tape you can use Velcro. I used Velcro and it holds very well.
great video, worked just like you described it! Thanks
I don't think there's footrest in Focus equipped with Auto Transmission too...or at least in the US-Spec Focus (We've always gotten water-down version in any Global model).
Thanks! I'll switch to Velcro too if the original d-tape on this aftermarket footrest couldn't take my abuse. :)
Feel free to share my videos and your ideas!
Why my new car 2021 model manual transmission doesn't have foot rest ? It's a Toyota
Mostly because of Cost and Space in that firewall area. You can still tape something there to avoid staining the carpet when your left foot is not actively engaging the clutch pedal.
Omg it's a peddle, stick it on. your making it out to be a complicated surgery. stick it on already
measure twice and stick on once
Not 45 min worth discussing
45min?
If you take it off, don't pull on it. Take a sharp knife and kind of cut the space between the tape and the carpet to keep from pulling all the fibers out.
GOOD VIDEO
the reason why you do not have that part cause you are manual not AUTO
BUT YOU STILL GOOD!!!
ff6947tw manuals have dead pedals too Ford Fiesta st has a dead pedal something to rest your foot on while not pushing the clutch
I want to remove the dead pedal not add to it. I hate dead pedals. I want more room for my foot.
Ford Focus doesn't come with dead pedal in stock, just bare carpet in that area.
I'm sorry but this video is terrible. It is much better to buy a small package of 3m velcro and only use the rough side. Cut it into strips and place around perimeter of back of dead pedal and then stick the velcro right to the carpet. Then you can remove it any time you want and you can also clean it easily.
...and that dead pedal is $7 on ebay now. It is terribly cheap and the treads will push in. the metal is very flexible. If you want a good deal on a real one get the Steeda aluminum piece.