How to Replace HVAC Blower Motor Assembly 2008-2013 Nissan Rogue

Buy Now!
New HVAC Blower Motor Assembly from 1AAuto.com 1aau.to/ib/1AHCX00341
This video shows you how to install a new HVAC blower motor assembly on your 2008-2013 Nissan Rogue. The blower motor, and typically integrated fan, is responsible for blowing the heated or cooled air from your heat or AC system into the cabin of your vehicle. A fan could become noisy if it is broken, or could stop spinning all together.
This process should be similar on the following vehicles:
2008 Nissan Rogue
2009 Nissan Rogue
2010 Nissan Rogue
2011 Nissan Rogue
2012 Nissan Rogue
2013 Nissan Rogue
Tools you will need:
• Phillips Head Screwdriver 1aau.to/obip/1AXAA00013
• 10mm Socket 1aau.to/oa8t/1AXAA00017
• 13mm Socket 1aau.to/obsf/1AXAA00015
• 8mm Socket 1aau.to/oa8t/1AXAA00017
• Trim Tool Set 1aau.to/o9T/1AXXX00006
• Needle nose pliers 1aau.to/oC2/1AXAA00051
• Needle nose pliers 1aau.to/oC2/1AXAA00052
• T20 Socket
• Socket Extensions 1aau.to/obsf/1AXAA00015
• Swivel
• Gloves 1aau.to/o3c/1AXSS00048
• Safety Glasses 1aau.to/oUm/1AXAA00343
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@oliverchadwick4]

This video saved me $350. So helpful. If there is one thing I could add it would be, when reinstalling the pedal set, remind people to be sure that the brake bar is between the brake U-bar. I failed at that and it cost me 30 minutes. Beyond that, this video was phenomenal. Thanks so much.

[@Andr3tti24]

This by far is one of the most clear and comprehensive walkthroughs I've seen. The camera angles up under the dash helped a ton to see what I can't when laying upside down on the floor!

[@TD16V]

Great video. I really struggled getting the new one in and seated so I could rotate to lock it in, and realised a wire had dropped inside. Only wasted 15 mins and 100 cuss words before figuring it out. 😂

[@jamesorr1200]

I just did this for the second time in three years. Removing the actuator motor made all the difference. Thank you!

[@fjesus347]

Thanks for your help, I solved my problem. It really took me a while to do it, but in the end I did it.

[@jesusgutierrez145]

Clear, concise instructions. Best videos. I would recommend removing the driver's seat, replacing the blower motor resistor and the cabin air filter since you're already in there. A faulty blower motor can definitely damage the blower motor resistor.

[@D1NSX]

Great video. Followed it step by step and son and I pulled it off and back to blowing cold air again. The only deviation we ran into was what you show at 4:02 min in, the pin in the break peddle. Ours was installing the opposite way and took small hands, video feed and a lot of swearing to get it pulled out. At least we installed back the proper way after. Thank you!

[@sam_draws_good8273]

Best video walking through the repair yet. Thanks for the help! You were clear and concise!

[@turnerway14]

Looks like a total nightmare. I’m thinking about just paying somebody for this one 😂

[@nexxusty]

There's absolutely no way I'm going to be able to do this without removing the front seat.
Appreciate the video!

[@djinsect]

I have a/c blowing again, thank you! Saved my girlfriend from the Texas summer sun.

[@noodleloves]

Just did one today. Pulled the driver seat and laid on my back. A bit fiddly as expected from Nissan. Junk design.

[@VictorHugo-kx1bt]

Couldn't have done it without this awesome video! Thank you!

[@rogerakline6148]

Excellent video! Just to add a few things. With everything out its a great time to change out cabin filter. Also if you a bigger person I took out my front seat. That allowed me to lay on my back and see everything as I was doing the blower motor removal and install😊😊

[@DadwithDaughters89]

I absolutely love these videos, I just used this video to do my fan in my Rogue. Thanks for the help!!

[@Caddilaclizard]

Just finished this job. It is not difficult if you have basic tools, and are somewhat skilled. My tips are replace the fan resistor and cabin filter at the same time while its apart, and remove the seat it makes it much more comfortable and a better angle to get at things. Overall, it's not a terrible job.

[@naduane13]

Great stuff brother! This worked for me. I edit or tip if I may? When re installing the pedal assembly make sure the u shaped brake bracket is on BOTH sides of the brake pedal. You were 100% that sucked but is wasn't that hard. Thank you.

[@TRQ]

+@naduane13 Thanks for watching our video! 1aau.to/m/Shop-TRQ

[@luismunoz-sy6mx]

Muy buen video sólo aseguren de colocar bien el pedal del freno y meter la cabeza debajo del tablero no es nada fácil, pero lo pude hacer,gracias por su ayuda

[@ShiftyGearz]

This helped a lot thanks bro just did my girlfriend's blower motor. This def helped 💪

[@diegoacostaperez9035]

Good 👍 👍 job

[@luismarmar]

Very nice!! 🎉I saw your video and changed the fan just like you did.

[@user-yq7ek7mt4t]

I want to check my blower motor relay to eliminate that as the cause of my problem, but I can't get it out. I assume it would just pull out, but the blue plastic box comes off , and the guts stay attached. Am I missing a release point ?

[@The_Wanderer...]

Extremely helpful thank you

[@jeffjohnson8476]

Thank you all! This was very helpful!

[@jaredvahl9142]

Do I really have to take all that apart or is it for easier access? My heat completely stopped working a few minutes ago and it's getting cold here in NH

[@nalds6]

My blower works intermittently.. we replaced the original 2 years ago and now it is acting up. Someone suggests to replace the resistor first before replacing the motor. What do u guys think ? Labor is 200, another After market motor is 240 in Edmonton Canada.

[@timbryant7088]

Great video!!! Great information!!! Love your videos, keep up the good work!!

[@dannyanderson854]

How do I know if I need a fan or just the resistor?

[@SHAREMediaBK]

Thanks! This video was a lifesaver!

[@rasmadrak]

Tip: While you're there with the pedals removed, replace the cabin filter and the HVAC resistor, as well.

[@TRQ]

+Robert Bjärmyr Thanks for the tip!

[@mikeswanson6145]

How long should it take your average weekend mechanic? Did you edit more than half?

[@marcusdarnell3348]

Can you remove the actuator before you take the motor out?

[@erictyler6371]

On a 2015 rogue it’s you can access the blower motor behind the glove box

[@TortureBot]

Did you ever reconnect that loose piece of ductwork that directs air towards your feet? It's shown at the 12:12 mark to the right and I never saw you reconnect it.

[@asankovlogs]

My check engine light is on now???

[@krazy8ightz270]

I can't get it to plug in. Super frustrating

[@narcodomusic3418]

wtf! too much work

[@franciscomedinav]

Im gonna do this.

[@cmart3131]

Why not go through the glove compartment area. Remove the glove compartment on the passenger side? I just watched another video that shows that

[@AngelReyes-do2co]

Your video didn't help a lot. Thank you very much

[@olenmullins1333]

I’ll never buy another Nissan again