LCA & Subframe Brace (Function 7) EK,EG,Del Sol, integra

In this video I will show you how to install new LCA’s and a subframe brace made by function 7! This video is just a quick how to install and can be challenging so be patient and you should be just fine!

[@theorylolz]

Just got a set of these in the mail gonna try in the morning 👍🏽 using this video for reference

[@theorylolz]

Location for the sway bar ? Or is it optional now that you have a subframe brace

[@builtjfilion934]

You can buy the sway bar set up I didn’t opt for it.

[@lsvef9]

Ordered the same set, be careful the bushings lasted a couple of months before they completely fell apart

[@builtjfilion934]

Thanks for the tip I’ll be sure to upgrade them!!

[@oscardlr4284]

Ty 🙏🏽 good descriptions👌🏽

[@timbuktoo7050]

Default position. I like that. Good vid. Where u from?

[@builtjfilion934]

Thanks for watching!! I’m from Rhode Island in the usa

[@timbuktoo7050]

Respect from Boston

[@builtjfilion934]

Thanks for the support! Appreciate you 💪

[@bacon2589]

How the hell do I tighten the bolts when the car is down I don’t reach my car is slammed

[@builtjfilion934]

This is hard but it can be done, I do slammed cars at a shop on an alignment rack. If you’re doing it at home the best thing I can tell you is to use a jack to jack up each side of your suspension one side at a time as much as you can and then tighten the necessary bolts down.

[@Kowalskithegreat]

Put some wood blocks under the tires to raise it up, that's how I did mine

[@builtjfilion934]

@@Kowalskithegreat that works also

[@asianmanfromasia]

I got the same set. Did you have any issues with the threads? Threads in aluminum seem like they would strip out easily

[@builtjfilion934]

Yes you must be carful not to cross thread aluminum but for the most part it’s been fine

[@VarietyTipok]

So my bolt area that the bolts to this are too small ad go side was instead of up and down, any recommendations wha I can do to make the subframe brace to work and bolt in a different way with different bolts??

[@builtjfilion934]

So the two bolts that mount to the rear subframe know to brake overtime. So just cut them out if necessary and put new bolts with nuts on the other end. I’ve done this in the past it’s a pain but not the end of the world!

[@wendisukmadarmawan]

helpful 👍

[@builtjfilion934]

Thanks for watching!

[@squiddyfly]

How are they holding up?

[@builtjfilion934]

Good honestly, I’m dropped about 1.5-2” every bolt was tighten when the car was at it ride height to avoid premature bushing wear, once they go bad I’ll upgrade them to red polyurethane ones.

[@harrisonwells8261]

Where can i get new bushings

[@builtjfilion934]

Online eBay search up Lca bushings skunk2 sells them

[@harrisonwells8261]

@@builtjfilion934 do skunk2 bushings fit the eBay function 7 LCAs