Kubota B7100 PTO seal replacement
HTML-код
- Опубликовано: 6 ноя 2020
- Kubota B7100 rear PTO seal replacement.
Remember to like, share, and subscribe since it really helps me out and inspires more content.
If you have any questions, tips, or tricks please leave them in the comments. Авто/Мото
Rear cover mounting screws torquing spec is 28.9 - 47.7 foot pounds taken from Workshop service manual Kubota tractor
39.2 to 64.7 N-m
4.0 to 6.6 kgf-m
28.9 to 47.7 ft-lbs
And yes the gasket is available @ Kubota dealer
Thank you. My shaft on pto is twisted. I do believe I can replace it by myself now. Thanks so much.
Glad the video was able to help. It’s really simple to do it yourself. If you need torque specs or a diagram Kubota dealers are usually willing to help. Typically good service.
Have you tried taking off the seal without taking the cover off? A sharp L shaped screw driver could do it. Also, there is not gasket for cover, it is some kind of paste sealant.
Yea, I'm pretty sure you don't need to take the cover off to replace the seal. Just drain a gallon or so oil out and pop it out with a screwdriver or something. Also, you can use the old seal with a piece of pipe to set the new seal in place.
Gasket is discontinued
Should someone just use RTX if the gasket is discontinued?
Just replaced the PTO seal on my B6100. There is a rear gasket for the PTO cover. Kubota part #66905-12220