I have the laptop and what i found is there is power light on when i plug the charger but no charge light. I hear the drive spinning but machine does not boot fan does not spin and did not find it short to ground. Any Advice?
You need to troubleshoot the laptop step by step because your problem can be cause by different things.. firstly take out the battery, clear CMOS and try to power again.. more steps to take if that doesn't solve your problem
@@borvitech Thank You I have done all of that and I have not had any joy yet I could give up but it aint in my DNA I will keep trying. So I will learn.
It was set on 12v -3amp but I don't recommend that you can start with 2v then reduce your current to 1amp and if there are no hot component gradually increased the current. THANKS
@@mornemckenzie2530 use your multimeter to look for shot but it will take you time to location it .. remember when there is shot on a power rail the all rail will be shot to ground
@@santoscomputer6851 I have had no short on the power rail 19v I have the 3.3v the 5v and 1.8 on the bios chip I will test the pin 2 to see if it fluctuate it might be a corrupt bios. But I just can't get the clip to remain on my chip on the board. omg.
Nice video 😊
Nice video and quick fix
I have the laptop and what i found is there is power light on when i plug the charger but no charge light. I hear the drive spinning but machine does not boot fan does not spin and did not find it short to ground. Any Advice?
You need to troubleshoot the laptop step by step because your problem can be cause by different things.. firstly take out the battery, clear CMOS and try to power again.. more steps to take if that doesn't solve your problem
@@borvitech Thank You I have done all of that and I have not had any joy yet I could give up but it aint in my DNA I will keep trying. So I will learn.
how much have you set your power dupply to to check for the short so you dont blow anything on the board?
It was set on 12v -3amp but I don't recommend that you can start with 2v then reduce your current to 1amp and if there are no hot component gradually increased the current. THANKS
Yes 12v-3amp I don't recommend that.. but start with a low voltage and current. THANKS
@@santoscomputer6851 What can I use if i dont have a power supply? I am still awaiting on my delivery
@@mornemckenzie2530 use your multimeter to look for shot but it will take you time to location it .. remember when there is shot on a power rail the all rail will be shot to ground
@@santoscomputer6851 I have had no short on the power rail 19v I have the 3.3v the 5v and 1.8 on the bios chip I will test the pin 2 to see if it fluctuate it might be a corrupt bios. But I just can't get the clip to remain on my chip on the board. omg.