Of all the "DIY" videos I have watched on RUclips, this is one of the most comprehensive. YOu showed all of the In-and-Outs of each step. Thank you for a thorough job!
Great instructional video young man !! Would love to see the electrical diagram drawing of the water temperature operation . What controls fan and how long it runs ect…Please .
Thank you Steve and I do have a little more to do with the mule. If I get the time, I'll say something about the electrical diagram pertaining to the water temp circuit.
So did cleaning the carburetor fix the running problem? I didn't really see anything in your cleaning of it that would have caused your problem of running good for 10 minutes and dying. My buddy' Mule is doing the same thing.
@stuzman52 I seen that. Usually, though, a blocked jet will cause running issues from the start, not after 10 minutes. Just trying to figure this one out!
Of all the "DIY" videos I have watched on RUclips, this is one of the most comprehensive. YOu showed all of the In-and-Outs of each step. Thank you for a thorough job!
Thanks for watching and sharing a comment! Have a great day!
Excellent, thorough video. I need to adjust my idle and mixture screws and you showed exactly how to do it. Thank you!!
You are welcome!
Hey thank for the video. Tore one of these down to do floors and engine, forgot which was fuel inlet and evap. Helped me a ton 🤘
Glad to hear video helped out! Have a great day!
Great instructional video young man !!
Would love to see the electrical diagram drawing of the water temperature operation . What controls fan and how long it runs ect…Please .
Thank you Steve and I do have a little more to do with the mule. If I get the time, I'll say something about the electrical diagram pertaining to the water temp circuit.
Where did you obtain the service manual?
I just did a google search for it. Have a great day!
So did cleaning the carburetor fix the running problem? I didn't really see anything in your cleaning of it that would have caused your problem of running good for 10 minutes and dying. My buddy' Mule is doing the same thing.
It was mentioned in an earlier video that one of the main jets was partially blocked with debris. Thanks for leaving a comment!
@stuzman52 I seen that. Usually, though, a blocked jet will cause running issues from the start, not after 10 minutes. Just trying to figure this one out!
How many turns out from seated are the mixture screws as a base line?
That would be two turns on the intitial setup. Thanks for watching the video and for the comment!