Vlog #5 Installing the Mivv Oval Slip-on on the Hornet
HTML-код
- Опубликовано: 29 сен 2018
- Hi everyone! We're back in the shop! In this video James is installing the Mivv Oval Slip-on on his Honda Hornet. The DB Killer is already out since the video so you guys will probably hear it in the next one ;-)
Please like and Subscribe ;-)
MY CAMERA: amzn.to/2I5XbZs
MY MICROPHONE: amzn.to/2timrZ8
MY GOPRO: amzn.to/2oTsdv1
GLIDECAM: amzn.to/2tq6IaE
MY FAVORITE LENS: amzn.to/2GqFF4j
SECOND FAVORITE LENS: amzn.to/2vgq5Up Авто/Мото
Keep up the good work! Videos look really good.
Thanks man that's very nice from you! ;-)
Hi there bois, I love this exhaust and am considering getting it for my 2005 Hornet 600. But I have the stock license plate holder installed, and I'm concerned it will interfere space-wise with the exhaust, since it does look quite big. Do you know whether I'd need to change it/do some cuts to the plastic?
Hi man, I honestly don't know if there would be any fitting issues with the license plate holder but I can imagine that it shouldn't be on the way as the Mivv isn't really much bigger than stock. Unfortunately the bike is sold so I can't check for you. Thx for the comment 😊
The video look pretty good and bike too. I just have one question, do you need to do some changes in motorcycle, after you install this slip-on exhaust? Like do something with carburetor?
Have a good day😄
Thx for your comment, usually changing a full system or just the silencer will make your bike run a bit lean but with the Mivv and the DB killer in it was honestly alright and we didn't do anything to the carbs. I could imagine that without the DB Killer some adjustments would have been necessary. Best is to pay attention to how it runs, if it back fires or not, check your plugs or take it to a dyno. Hope that helped 🙂
@@brucesmotorcycleshop3729 thanks for quick reply. I bought the same exhaust on my Hornet, so I was just curious. Thanks again👍
Gutes Video Männer! Wollte mir den MIVV X-Cone noch den Monat bestellen. Habt ihr einen Tipp zum abnehmen der Heckverkleidung? Muss man das Plastikteil vorsichtig aufbiegen oder wie macht man das am schlauesten?
Hi Alex, thanks for the nice comment, just like you said you have to pull the rear plastic open a little bit and slowly slide it towards the back! You can see it on the video @2.52 when James is putting it back. Just be careful with it and pull it out slowly and that will be fine! Hope it helped ;-)
where is you bought the middle link pipe?
Hi, it was all included with the slip-on... you can probably get it separately from Mivv