It make sense , plastic retracts do to sponge effect, and you have increase the gape between the paper and printers head with just a sticky tape 😂🤓 That’s clever !!! Thanks
Hi, thanks in advance for your help and interest. I have a problem with a HP7500A and that is that after changing the printhead the machine has entered a loop and only shows the animation for instructions of how to install the printhead. You can switch it off/on or unplug its back plug, but after loading its routines shows the animation once again. I tried several procedures as pluggin with 6 and # pushed, home+return+home+home after pushing ten seconds the on button while pluggin it or pushing four times return button, but nothing works, it only shows the animation and no other button lights or works but the pause or >. Please any help would be so much appreciated, I'm almost desperate. Thanks.
Did both adjusted spring and that didn’t work. Then used tape and doubled it even. Same print head failure. I had the print head fail a few years ago and all of a sudden it worked again. It’s old. It’s done
Hi i have tried this but printer say " Remove all ink catridges, next lift gray latch and remove printerhaed. then re install printhead and ink cartidge can you help even after new printer head same prbm
Worked for me. I didn't use the sticky tape, I re-shaped the spring to make it push a bit harder instead. The principle was spot on though.
Easy to assemble, good strong materials, feels good, looks good.
It make sense , plastic retracts do to sponge effect, and you have increase the gape between the paper and printers head with just a sticky tape 😂🤓
That’s clever !!!
Thanks
THE MUSIC DOES NOT HELP FIX THE PROBLEM, dugh...
Hi, thanks in advance for your help and interest.
I have a problem with a HP7500A and that is that after changing the printhead the machine has entered a loop and only shows the animation for instructions of how to install the printhead.
You can switch it off/on or unplug its back plug, but after loading its routines shows the animation once again. I tried several procedures as pluggin with 6 and # pushed, home+return+home+home after pushing ten seconds the on button while pluggin it or pushing four times return button, but nothing works, it only shows the animation and no other button lights or works but the pause or >.
Please any help would be so much appreciated, I'm almost desperate.
Thanks.
what did you do with the metal piece?
Did both adjusted spring and that didn’t work. Then used tape and doubled it even. Same print head failure. I had the print head fail a few years ago and all of a sudden it worked again. It’s old. It’s done
Good Day what did you put on the back of the plastic strip?
SimplyBS I think is a double side tape!
At 10:50 you can see in the back ground a insolation electrical tape!
But I think is dunked side!
Hi i have tried this but printer say " Remove all ink catridges, next lift gray latch and remove printerhaed. then re install printhead and ink cartidge can you help even after new printer head same prbm
Welcome ,0x19a0020 error what is the solution? printer model:hp 7500a
Αre all original or have you tried a 2nd printhead?
Ista ka machine ha mara pas pindi islmamabad ma b nahe ho geya koi bhi ko ptq ha tu information dado
well this doesn't work. you didn't put the metal piece back in. my printer is junk now, I don't know how to put it back
Ugh…. I am guessing Mine is now going to be junk! I have no idea what to do with the metal piece?
one of the worst printer ever to buy waste of money n time.
What printer you prefer?
With so much advertising in a 15 minute video you could have at least bought a tripod.
Didn't work