Great work! Thanks for sharing. You can use the built in measurement tools for counting teeth either rising or falling edge count between the rulers. Let me know if you need any support.
I got a cat gp40k 10k lift capacity it’s got the Nissan tb45 I tried replacing the Nikki regulator still won’t start if I hold fuel line unhooked letting air in it fires a little. Any ideas? How do I communicate with the computer to check codes I don’t see any lights on the dash nothing even comes on.
Start of the video I knew it was timing had that about 10 times now only 3 of them needed new cranks I replaced 2 and replaced the whole engine out of a spare truck that came off hire but I find them GM’s out of balance and go through timing belts, tensioners and crank gears like there’s no tomorrow every maybe 5-6000 hours
Great video! I have the same forklift I’m trying to fix. It won’t run, the injectors are not getting power and firing. Doesn’t have any faults. Lift runs fine if I spray something flammable in the intake. What would cause the injectors not to fire?
I had that exact thing happen to mine must be a common thing. After the crank was fixed, it revs up but dies at high rpm not sure what's wrong with it now, runs great before it hits that rpm range then cuts out. Any suggestions?
Hello sir by chance you give tech help over the phone I not I understand iam a forklift technician need help on a wiring issue thanks if not it's ok just thought I'll ask
Thanks for sharing. I see how important a good ref signal can be.
Thanks got lots of trucks with that engine this may help
Great work! Thanks for sharing. You can use the built in measurement tools for counting teeth either rising or falling edge count between the rulers. Let me know if you need any support.
Thanks for the tip. I'll definitely try that out.
I got a cat gp40k 10k lift capacity it’s got the Nissan tb45 I tried replacing the Nikki regulator still won’t start if I hold fuel line unhooked letting air in it fires a little. Any ideas? How do I communicate with the computer to check codes I don’t see any lights on the dash nothing even comes on.
I just looked at one exactly like this a couple days ago, same issue.What are the odds. Crank no start .
Can you tell me how to set the timing on the motor please mine through a belt. Thank you for your time.
Im looking for that too can´t find it
wow nice diagnosis .did you change the crank or weld
Just came in to diagnose it.
Start of the video I knew it was timing had that about 10 times now only 3 of them needed new cranks I replaced 2 and replaced the whole engine out of a spare truck that came off hire but I find them GM’s out of balance and go through timing belts, tensioners and crank gears like there’s no tomorrow every maybe 5-6000 hours
Great video! I have the same forklift I’m trying to fix. It won’t run, the injectors are not getting power and firing. Doesn’t have any faults. Lift runs fine if I spray something flammable in the intake.
What would cause the injectors not to fire?
Fuse F3, fuel/run relay RL2
Ok thanks! I’ll check that first thing tomorrow!
I had that exact thing happen to mine must be a common thing. After the crank was fixed, it revs up but dies at high rpm not sure what's wrong with it now, runs great before it hits that rpm range then cuts out. Any suggestions?
Hello sir by chance you give tech help over the phone I not I understand iam a forklift technician need help on a wiring issue thanks if not it's ok just thought I'll ask
why that could happen ?