Видео

Great job on video..👍

Its interesting to see this video is from 4 years ago . The price has gone up so much its crazy . Still cheaper than buying shop wine though 😉 thanks for the video 😁

Might be a silly question but I can't get the screws out? I assume they're just normal cross head screws? Can you confirm please

Bonjour j'ai aussi un T4 1.9d l'eau ne circule pas dans le bocal pensé vous que sa peut être le thermostat ?

How deep is the hole?

Does this mean that your alarm, Canbus, immobiliser, electronic parking brake are all running off your leisure battery when you close the car and lock up for the night? Then there will be no drain on the starter battery under the bonnet?

I didn't know VSR isolators existed. Thanks.

Regarding the pump - if the two directions of out-flow are connected by a common chamber, then the dribble from the front-now-rear outlet will be much higher if the rear-now-front port is blocked, which it should be if rear not being used, allowing pressure to build. In fact I think you might have a hole in your line to the rear wiper, which caused the loss of flow to the front. Flipping the motor masks the issue, and your fluid levels will drain faster, obviously. But what do I know, i could be talking out of my arse.

Super, habe sogar ich verstanden obwohl ich kein Englisch spreche. Danke 👍👍👍👍👍

subscribed ! good luck and thanks for the video, in the middle of my own van build on my channel

Copper slip is great but should never be used on a moving part. Good for things like bolt threads .

@2:42 Put a switch there, eee I am JUST old enough to remember an acumulater swith for the MAIN battery together with a crank to turn the engine over if you battery ever went flat.

The curtains look great 👍

Apart from the thermostat seal is there a thermostat housing seal?

Is this the 2.5tdi engine?

Joe from United States good job it was helpful

What if the pump just keeps spinning hence te belt wont hold it steady? Nevermind I figured it out, but it happens.

Can this same method be done with a lithium battery? Cause I’ve done this exact same method but only difference is that I have a life po4 200ah lithium battery. It worked for a short period of time, but now my voltage drops from 12.8v right down to below 11v within 10 mins of using anything that’s wired into it. I know sweet FA about electrics and this battery cost me about £400. Which if it only worked a handful of times, seems to be a complete waste of money. I need help 😩

Thank a lot ;-)

dude you are so funny I love your videos and I also learn a lot :D.

Joel, the others all said it well, thank you for your videos, you did an excellent job!

Thankfully i found your channel I've saved plenty plenty dosh to spend on some other things for my van thanks so so so much even though its been 6 years since you put up 😉

✨✨🤍✨

Brilliant straightfwd stuff 😊

hi, is the reason that you had to swap the connector of the high pressure line because you purchased the 7D0 422 155 F and your one was the 7D0 422 155 ES ?

Great idea 🎉

Great thanks.

there is no tensioner in my van, so i suppose i have to slack pff the alternator?

Great video, I’ve just bought my starter motor and now feeling confident to change it myself ^_^ also the lush music really calmed me after finding out I need to buy a new starter motor ;) thank you 🙏

Do you not need a turret plate on the floor or is it ok to just put it straight through to outside will exhaust not get to hot and burn insulation under the floor cheers

could you have two leisure batteries (wire them in series for higher voltage to power a fridge etc, or wire in parallel for higher capacity?) with this split charge system?

simplified to a novice, nice vid thanks mate.

Personally I would just cut back to 'SOLID METAL' and cut and fit, your new panels to fit the 'SOLID ORIGRINAL' bodywork! dx

😊

I have this exact model, can you help on how to remove centre console? And door panels lol

Bang on. As for red earth cable just loop some black tape round each end to make it stand out

why didn't you check the shape and size before ordering the part? great vid though

This is the video I needed to see. I wish you were going to go into smart alternators and how to navigate these.

Hi bud your video is a great help don't suppose you can send me the item number and where you got it from

Thats my Quest tomorrow, thank you!

i might go back to my splitcjarge vsr thing to see how much charge my lifepo4 gets .

hi.my vw t4 2.5tdi used to have a vsr charger .i fitted a dc victron charger well have 2 now 18amp and 30amp dc chargers but recently they stopped charging to their capacity only getting about 10amps for both of them don’t know why.my 105ah lifepo4 battery needs mains top up every few days .i have parallel my old 12amp dc charger too with an isolater switch as i connect the 12amp charger to my other agm battery 105ah to my stereo power amps 2 kenwood .so get about 16amps when all 3 chargers parallel.seems like waste of victron dc chargers 300£😂i checked wiring seems ok.

I've just ordered new glows plugs n stater motor. As my glows plugs where on there way out, i tired doing the whole spray into the air take. Worked once, then tired that again. Then ended up frying my stater motor 😅

What’s a DC to DC charger? Are they different?

Fair play good job im a welder and own a T4 which im in the middle of doing this ... not the easiest of things to do even for me but the end results are all worth it . Good job

@Joel's Stuff i. does this use more diesel or is it excess electric from the engine? ii. can this charge a lifepo4 leisure battery?

Absolutely brilliantly explained.

Hi, I have just cat B on my licence, when I pass cat D, I will receive any other category on my licence?

great vid, I need to do mine so this helps loads. although when flushing it's best to use de-ionised water It won't leave scale build up in your cooling system. Regular water contains hard water minerals which can leave a build up of hard water deposits