Видео

I'm not quite sure what you mean here.

Thank you very much. Greatly appreciated!

From the bottom issue? Was that your problem?

Thank you so much!

They didn't make the market? I don't even know how to respond to that. Where do you think the one in this very video came from?

You only need 1 gateway (depending on how big your house is, but it would have to be pretty large for 2 gateways I assume). I have my gateway down in a corner of my finished basement and 1 of thr ##$sensors is in my master bath which is on opposite sides of the house upstairs. So I don't think you would ever run into that issue unless you're Money bags McGee!! Haha

@@threadchemistry THANK YOU so much! I bought the package of hub + 3 sensors, for the basement, then an additional 2 sensors without the hub, for the first floor. So, I'm going to keep the 2 additional sensors and set them up. Thanks, again - taking the time to reply is appreciated.

@@threadchemistry PS - watched a n umber of videos to set up the Govee Hub, etc. Your's was, by far, the best - easiest to understand and your instructions were inclusive and said w/confidence and knowledge. Gonna subscribe. Again, thanks.

Thank you. Much appreciated!

I'm not 100% but I don't believe so

Keep about 40 clean pairs on hand. Different colors. All Airmax Plus from my guy Tinker.

They may have appreciated more than certain stocks! By the way was the lock easy to install?

Ya pretty simple

It's all personal preference. But the dryer it is the higher you want it especially if you feel it personally. If I were you I'd start high for a week or 2 and adjust from there to your liking

@@threadchemistryThank you for your reply. I will definitely try that. I’m also getting the hydrometer so maybe that will also help a little.

You could also get one of their air quality monitors and you van actually link it to different devices to control the rate of flow as needed from air quality instead of adjusting it all the time.

So I have heard about this from others. Apparently it still works. Just follow the directions as they are. Don't worry about the color. Should work from what I hear.

Yep I got it

Hello.. as of right now there is not a way to do this. I actually contacted Denon about this question and a few others and they replied to me that they are working hard to add options like this to their Alexa option..... but that was 2.5 years ago. Lol. Hope that helps.

@@threadchemistry Thanks for the reply. I would assume this is possible through the Heos app?

Correct

That is actually the tilt sensor. It's made that way so if it does tip too far it will automatically shut off so nothing catches on fire..

@@threadchemistry ohhhh ok that makes sense now. Thank you! 🙏🏼

No problem anytime.. ))

You mean just a little in the bottom when you lift the top off? Yes that's where it filters through so there will always be a little bit in the bottom. That cycles through.. as long as it's not leaking out and onto your floor, you're good.

@@threadchemistry thanks 👍🏾

Anytime

It's been so long I'm not sure what you're referring to? Is you remind me I can prolly help

I'm not quite sure what you're asking?

@@threadchemistry Thanks for replying to an old video. Was just wondering if you may have a fix to why mine wont show multiple colors at once. Like 2+ it will either stay one color or go full white.

Gosh it's been so long I can't even remember the setup. Have you tried Govee? If not you can email them at support@govee.com they should be able to answer best for you!

👍

No, this specific device does not work with homekit currently. But I know they're incorporating it in their newer products and their cameras. This one is not though.

Yes

@@threadchemistry cool, thanks!

You're welcome

Yes

@@threadchemistry Thanks!, I know I asked you the same question with the other device too, lol

Lol all good. Good luck.

Yes

For sure man. Thank you.

Haha. You're welcome

Awesome just keep the list growing. I've been doing this for a few years now and I must say Govee is definitely in the top 3 in terms of connection, stability, app ease/layout, and certainly personality. I've never had a problem with any devices failing or losing connection so it's definitely a great brand to add to for your home.

Hey man! Sorry about the late response. I didn't get the notification for some reason. To answer your question, yes you can set start times, stop times, adjust speeds for different times. (Speed 2 for 3 hours, then speed 4 for 1 hour, etc) so it has all sorts of options that go with it.

It just sits there kinda. It has a folding back to kind of move the center of gravity back and rubber for grip. Hips very well actually

Yea I actually have some I bought recently! I haven't put them up yet but they look like something I can dig! Ha.. I'm still gonna do a video with the m1s and the V channel Muzata diffusers. Just bc they're meant for corners and a bit bigger to fit the in the corners. Otherwise, I will try these out soon and prolly post it! Thanks for the post and the continued support my man Rodney..

@@threadchemistry I bought this new house and my office has 0 daylight because it's in a finished basement. Since that's the case, I have UV and Govee lights to help simulate daylight (why I chose this room? it's 12.5x12.5 and the upstairs all have rooms smaller than 12ft and my desk is custom that runs near 10ft wide[[which utilizes a govee neon rope light 2]] ) Oh, and to complete the look, if you haven't already, add a strip under a couch (if it's a sectional, even better!) My entertainment center has lights behind the TV and under the couch--govee of course. I have so many govee products but not the new hex lights--too chunky of a price to purchase!

Ya I have 2 sets of the hex. 1 is up. I don't really care for them. Ya I have lights under the couch. I have lights in places I didn't know existed before i started. Haha Sounds like a nice office you have.

They are very durable. This specific holds up surprisingly well.

Thank you very much.

Just needed a little extra heat in that spot.

All of those are the same thing. It's 600 bc it's 600 microns thick. It's not very thick. You can buy thicker vinyls if the Siser isn't rich enough for you.

@@threadchemistry Well, the thing is I don't know I have received the real deal, provided on what I see in your videos and other videos... or maybe people use brick in the video (1000 microns) but they call it brick 600 (600 microns) anyway... and that has confused me.

Microns are just the thickness of the vinyl.. like a human hair is about 20 microns thick.

@@threadchemistry Yes, I do know, but my concern is if people call it Brick 600 even when they are using in the video brick (1000 microns or 1 mm thick) and so it is confusing, you buy 600 thinking that it is what they show in the video but you get 600 which is nearly half the thickness...

@@Fancylooks well having concerns like that is only going to give u a headache. 😜

Thank you very much! That's very kind. Glad you liked it! Thank you!

Awesome! Enjoy! Let me know if you have any questions!

Haha yep. Sorry I already fave out the motion detector. Check the next video though! I'll be doing it in every video..

Reads the color on the TV to project that color.

Yes. All older models with update to the new hb3. Once it connects you might want to restart it I've heard as it gets stuck in 720p and u want 2k.

Yoo. Thanks, man. You can shoot me an email if u want and we can talk there. threadchemistrytshirts@gmail.com

@@threadchemistry Just did check email.

K. I'll reply in the am

What about when you wash the clothes? Does it get damaged?

@@CLAVIS949 nope. Made for washers and dryers

Thanks man

I have them for sale. If you look through my videos there's actually an updated video to this. I now have heat transfer tags. Let me know if you are interested. You can email me anytime.

They are just reference points to be able to spot those corners easier when going through setup. So technically you don't actually need them. If you could find something that you could put on each area of your TV where the orange foam pieces are supposed to go, you would be good to go. Probably something a little brighter so you can see it. Something that isn't going to stick to the TV and ruin it when you need to remove it. Maybe even some of those neon post it notes. The mini ones would probably work perfect. I hope that helps. Let me know if you have any questions.. ))

Ya I believe you can set 2, 4, or 8 from the actual device.

Actually I just looked and it's 1, 2, 4, or 8 hours from the device that will work without wifi

I'm going to be honest with you. This is basically for show. If you actually want to listen to music and skip around. I would just download and use the HEOS app.. However, if you did want to do this with the choice activation, yes you would need an Alexa device. You can pick up a dot for around $25 bucks I think..

Ffffff

Awesome! Glad I could help. I hope you enjoy. Let me know if you have any questions.

Bahah. Yes it is a cool light thingy.. haha enjoy