Видео

Would have been helpful to show heater instal

Thanks i would like to know where you get the addational coil wire and fan .

Did you install this while fridge is still running? I dont think defrost is working all the time?

I gaurantee there was nothing wrong with the fan...next time connect the red and black wires to a nine volt battery and see if it spins!

I have the same frig with ice build up after six (6) years. Question: 1: Why now? 2: What has changed? I see suggestions about an addition heater coil, but it ran for six (6) years. What is failing now? I have seen above that the entry point for coil may need to be reseated?

A little windy, NICE Red

Intex sand filter pump graveyard that’s already old broken ones

this fridge is such a piece of crap, nothing but problems since ive had it

My own update on this same repair..it still works ok. No icing up in evap area. I checked it six months in. I was ready to junk this fridge but we’re good I think.. never again Samsung! Btw the door flap is busted now but I saw a video and should be easy to fix for less than $20

All Masterbuilt gravity grills should have magnetic switches.

Do you know what is the front rubber tube used for, if it is missing is it gonna affect this working? Thanks

What brand pool? How did you install the skimmer in a temporary pool

I added a similar heating wire 2.5 years ago. It hasn't frozen up since.

Bro, salaam to you, i’m a conservative Muslim and we don’t like our kids seeing the garbage on the home screen. I really appreciate your guide. Salaam.

Thank you. Sad thing is I only looked this up because I got tired of getting advertisements for trans bs.

Where did you buy this net?

So im a first time pool owner and i set my pool up and it was 6inches off on one side. So i bought pavers but i was going to stack two of them that are two inches high to try and level it and then not put any under my other side. Should i not do that and if not how do i fix and level it? by the way im draining it to do this not with the water in it if that helps

Do not listen this awful advice. DO NOT CUT your butterfly gasket. Once you cut out your opening, the butterfly gadget will fit exactly as it is MEANT to do.

Me too

That's what happened to my refrigerator I had a repairman coming frosted but I can't order the part I have it put in until June I was just making sure he wouldn't sell me a lot of c*** that that would stop the problem that's why I like RUclips you can see other people figure stuff out

can we maybe get an updated video on what happened a yr later after the repair ??

Best above ground pump and filter you can buy. No question. Top notch salt system as well. Your plumbing on everything is outstanding. Great work!

Can u use broken pavers?

Never immerse the terminal ends of your cell in muriatic or hydrochloric ACID. It will break down the terminals and shorten the lifespan of your salt cell.

How did you install these?

Hi, could you explain to me how to diagnose that I don't get current to the fan?

where can i get this heater wire kit ,here i AU ? 240 volts ? and i dont like the "squash locks " for water cant we get something water /moistor /resistaent/ but yes i agree same prob, very good vidio .

Question: Is this a repair recommended by the factory or something you invented?

Cchmh

😢😢

😂😂😂😂😂😂

😮😮😮😮

Great video demonstration and thanks for including Amazon links 👍👌 one question: did you use the 18-14 AWG Blue 100 quick splice?

Where do I order the extra heater strip?

Do you think you should have sealed the blue connectors with silicone to prevent moisture from seeping in?

What is the voltage to the heater? Is it 115VAC?

I had the same problem. I just wrapped pipe insulation around the top right refrigerant lines and zip tied them in place and that solved the problem. If your getting water in the tray, it's might be a blocked drain nipple in lower back of the fridge.

You problem is the positin of defrost sensor. Can it relocated from right to center where is more ice. The sensore has yellow whire.

Take the defrost bi metal and move it to the top

Samsung marka en boktan marka, tüm samsung ürünler pişmanlıktır.

Update September 2023: I did this same mod on my Samsung fridge in October 2022 (11 months ago) and it solved the problem, but not perfectly. The main issue is fixed, that is, the frost over top of the evaporator no longer forms.🤙..however I do have an occasional (3x in 11 months) pooling of water under the bins in the fridge part which freezes into thin sheets. I clean it out in 5 minutes. It’s a minor nuisance to me but not everyone will be able to deal with it. I’ve adjusted the bottom part of the aluminum evap backing to try to divert all the falling condensation water but somehow a small amount occasionally drips into the fridge compartment instead of the drain hole. Still working on this issue. But the Samsung is now acceptably functional. I miss my old Kenmore!

My inground pool is 5 inches off I let the water out because I didn’t want anyone to get hurt since my pool is not in grass but concrete , would adding pavers on top of the ground be fine to level up one side of the pool ?

I was looking at the wires today and the white and black wires are cut., The installer cut them. weird?

I like that pvc from the filter ...mine came with hoses

Where did you get the cup holders?

so you buried your pavers?

Hey great video what kind of sand did you use for this project.

What adapter did you use to connect the Intex hose to the bottom of the skimmer? The adapter the skimmer came with is too big.

Perfect. Thank you.

Can you add salt to any above ground pool?