Can you use this project to add BME280 and NEO6MV2 GPS? if affirmative, Could you please explain the connections for the ESP32 and the NRF52840 DIY versions? Thanks!
You select in the Meshtastic setup which GPIO pins you are using for your GPS module. I added a GPS module to a Heltec V3 with no problems. Google howto add GPS to Heltec and there will be more guides. Should work just the same with a ESP32.
Can you use this project to add BME280 and NEO6MV2 GPS? if affirmative, Could you please explain the connections for the ESP32 and the NRF52840 DIY versions? Thanks!
You select in the Meshtastic setup which GPIO pins you are using for your GPS module. I added a GPS module to a Heltec V3 with no problems. Google howto add GPS to Heltec and there will be more guides. Should work just the same with a ESP32.
i have esp32 devkit v1 will that work ?? with the lora
Can you write Ra-02 and Oled display connections for ESP32S3?
@@uguraltnsy this is a different variant of the board. You will need to build your own custom firmware for this to work.
I looked at your page and found nrf58240 diy node. Is the C3 on the chip ble antenna? I seem to have issues connecting via ble.
@@NoroAmehr you have to tell me what c3 you have, then most probably you have to build your own custom firmware because the pins are different
Mine looks the same. I meant the red component designated as C3. Is it a capacitor or ceramic antenna?