Great video, I'm getting ready to do the exact same thing.. I have that tap already, can you confirm the drill size? Is it 7/8 bit size? Thank you in advance.
Website says drill bit size is Type R for a 1/8” tap. 7/8 is way to big. Drill America - POU1/8NPTW/DRILL 1/8" Carbon Steel NPT Pipe Tap and R High Speed Steel Drill Bit Set, POU Series a.co/d/5bnqfVB
Looks much better than one going to the radiator or upper hose!
@@paulpoor7792 I would have to agree.
Nice work👍😎🤔
@@danmartinez3390 I appreciate it!
Great video, I'm getting ready to do the exact same thing..
I have that tap already, can you confirm the drill size?
Is it 7/8 bit size?
Thank you in advance.
Website says drill bit size is Type R for a 1/8” tap. 7/8 is way to big.
Drill America - POU1/8NPTW/DRILL 1/8" Carbon Steel NPT Pipe Tap and R High Speed Steel Drill Bit Set, POU Series a.co/d/5bnqfVB
Great, thank you..
Just needed to be sure.
@@elpinchediablo6666 hope it helped you out!
Do you have the brand / part number for the Water pump?
@@RichardT123456789 ACDelco GM Original Equipment... www.amazon.com/dp/B0031I5YTA?ref=ppx_pop_mob_ap_share
what paint is that??!!!
@@shadetreerestorations9053 valve covers and timing cover are Cerakoted in patriot blue.
I was just about to ask I need this paint I’m going to paint my engine over again
@@3rdGenC10s looks damn good man!
I appreciate it.
How much does it cost to make one pretty?
Everything you need is in the description. Probably around $100. I’ve done quite a few of them so the cost isn’t as bad for me since I had everything.