I drove down the street got it up to 25 mph pulled over while your video was still going ran to the back and now I have air the pins released and the tandems slid😂😂
They had the tandems so far forward I had a job to get my arm up in there with the skirt. Then, the knob was perpendicular ... facing forward toward the tractor, instead of straight out the side of the trailer toward me! And I could barely get a couple fingers on it, let alone try to push or pull on it to see if I could make it go in or out. It seemed hard stuck. But couldn't get any leverage anyway, not even with a claw hammer! And no way to crawl under there. Woo-hoo, California here I come ... runnin' deep, dark, and wild in the dead of night! 🤷♂️ 🚛💥💨
If you're just trying to build air pressure back in your tank, instead of driving around, you can just leave it in neutral and idle up to around 1500 RPM until Primary and secondary gages on dash reach 120PSI (approx 1 minute)
My g…. You just saved me hrs of struggling 🙏 thanks
You don’t have to drive. You can release trailer breaks and keep your tractor brakes set. Rev motor up to fill the trailer tank pressure.
Same result without having to drive
I did that too....now I hate the air ones rather have the lever
Thank you this is what i needed and it worked!
Thank you for advising to ride around, it helped.... good looking out Bro
I drove down the street got it up to 25 mph pulled over while your video was still going ran to the back and now I have air the pins released and the tandems slid😂😂
Thanks so much. I was about to drop the trailer. I drove around & tried it again.
I'm glad it helped.
Bro! I was stuck for an hour and tried everything...thanks this worked got me rolling
Hadn't had this happen for almost a cool year, then it happens this morning😅 thanks for the vid bro I forgot😅
Maaan you saved my life ❤❤❤
For real 🎉
Appreciate it, bro
California has KPRA (kingpin-to-rearmost-axle distance) rules. Make sure the shipper knows if you’re going to or loading in CA
Thank you
Mine was rusted & i watched the guy on RUclips using the pb blaster lubricant & that's what solved the problem.
They had the tandems so far forward I had a job to get my arm up in there with the skirt. Then, the knob was perpendicular ... facing forward toward the tractor, instead of straight out the side of the trailer toward me! And I could barely get a couple fingers on it, let alone try to push or pull on it to see if I could make it go in or out. It seemed hard stuck. But couldn't get any leverage anyway, not even with a claw hammer! And no way to crawl under there. Woo-hoo, California here I come ... runnin' deep, dark, and wild in the dead of night! 🤷♂️ 🚛💥💨
Exactly 😊
If you're just trying to build air pressure back in your tank, instead of driving around, you can just leave it in neutral and idle up to around 1500 RPM until Primary and secondary gages on dash reach 120PSI (approx 1 minute)
Thank you for commenting.
You saved me
You saved bro. Thanks for commenting on this video
Amazing! It works perfectly, thanks man you saved my day!
u gonna show us?