🔧 Tips & Steps for Rebuilding a Trimmer Carburetor Successfully

Discover essential tips and tricks to rebuild your trimmer carburetor and get it running like new! If your trimmer won't start or leaks fuel, a rebuild and cleaning can likely fix the problem.
Amazon Affiliate Links:
Larger Ultrasonic Cleaner (Best): amzn.to/3VuJnPX
Budget Ultrasonic Cleaner (Good): amzn.to/3VzVxr1
Pine-sol: amzn.to/3Vjqs9B
As an Amazon Associate I earn from qualifying purchases If you place an order, thanks for support the channel!
*Video Overview*
1. 🔧 *Parts Comparison*
- Ensure new parts match old ones.
- Avoid mixing new and old parts.
- Check diaphragm pin height using a digital caliper.
- Compare lever angles and ensure the correct pin and lever combination.
- Inspect and replace the inlet needle; avoid reusing the old one.
- Carefully compare gaskets; even small differences matter.
2. 🧽 *Cleaning the Carburetor*
- Use an ultrasonic cleaner with a 50% Pine-sol and 50% water solution.
- Clean for about 10 minutes to remove all deposits.
- Link to a low-cost ultrasonic cleaner is BELOW!
3. 🔩 *Re-Installing Parts*
- Take photos while disassembling to remember the order.
- Ensure the lever moves smoothly; if stuck, re-install it properly.
- Tighten screws in an X pattern to distribute pressure evenly and prevent leaks.
4. 🛠️ *Fuel Lines & Final Adjustments*
- Replace stiff or cracking fuel lines.
- Re-connect throttle cable in the same hole as before.
- Adjust high and low screws. Reset screws if trimmer doesn't start.
- See THIS Video for the High & Low Screw Adjustment Procedure: • How To Adjust a Trimme...
⚠️ DISCLAIMER:
Use of the information in this video is solely at your own risk. The creator of this video assumes no liability for any property damage, injury or expenses incurred as a result of any of the information contained in this video. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result.
The creator of this video makes no claims, promises or guarantees about the accuracy, completeness, or applicability of the procedures and instructions contained in this video.
Any injury, damage, or loss that might occur as a result of improper application, improper use of tools or equipment, or from the information contained in this video, is solely the responsibility of the user.

[@CleverFix]

If you enjoyed the video, please give it a *thumbs up* 👍. Your support helps me create more content and is *greatly appreciated* . If you have any *questions* , *comments* , or *suggestions* for future videos, feel free to leave them below. I love hearing from you and look forward to your *feedback* ! Also check out my Carburetor Adjustment Video: ruclips.net/video/uff2RiJqebs/видео.html Thanks for watching. 😀

[@Kevinrichardsonministries]

Excellent Video... Great Camera Work... Thumbs Up... Subscribed....

[@CleverFix]

Thanks a lot, and thanks for watching, it's appreciated!