Kinda was working on that myself. I have a relief of stone 12 x12, was looking for a way to use this on let's say a letter or another shape other than a 12 x 12 tile. Oh actually just used my Jenny SJ. Very happy with it. I'll be replacing all my most used with Cadence. Thanks again for another great video. Always look forward to them.
If the place where it needs to meet up has a lot of detail its a bit harder to get them to line up and then sand that. I always try to keep a board on one side to keep that side aligned. I appreciate the feedback and hope this helps.
Struggling with tiling/paneling now. The gap isnt in Carveco, its in the machine. Wished there was like a sliding sled on the machine that had stops where u could slide your board down to the second stop for the running the second toolpath. But, the tips in this video, where you setup the vertical index piece coupled with indexing screws is a good method.
I have used this method on few projects and having that corner were I have the tape and the board down one side keeps it aligned. For me its easier to use screws for hold down so clamps and tape make.it harder to keep it aligned when you want to move the material. Hope this helps a little more and thanks for the feedback.
Kinda was working on that myself. I have a relief of stone 12 x12, was looking for a way to use this on let's say a letter or another shape other than a 12 x 12 tile.
Oh actually just used my Jenny SJ. Very happy with it. I'll be replacing all my most used with Cadence.
Thanks again for another great video. Always look forward to them.
If the place where it needs to meet up has a lot of detail its a bit harder to get them to line up and then sand that. I always try to keep a board on one side to keep that side aligned. I appreciate the feedback and hope this helps.
I'll give that a try
Struggling with tiling/paneling now. The gap isnt in Carveco, its in the machine. Wished there was like a sliding sled on the machine that had stops where u could slide your board down to the second stop for the running the second toolpath. But, the tips in this video, where you setup the vertical index piece coupled with indexing screws is a good method.
I have used this method on few projects and having that corner were I have the tape and the board down one side keeps it aligned. For me its easier to use screws for hold down so clamps and tape make.it harder to keep it aligned when you want to move the material. Hope this helps a little more and thanks for the feedback.