Great video! Just got my kit, looking forward to installing it. Would also love to install a stack light. Do you have a source for them and a video to install?
I installed my kit with no issues. Easy to follow instructions. Works very well on my Ruida controlled laser with lightburn as the software. Much better than my "manual" adjusting of air that was provided by the wheezing little onboard air pump. Hooked to my shop compressor, cutting and engraving results are far superior. I'm not affiliated with Artifex - but credit where it's due - it's a good bit of kit and I recommend it. Cheers from Australia.
Yes this is normal when the machine is unpowered with the normally open solenoid. There is a manual valve to turn off air completely is the laser is unpowered.
I did get my order, and it works great! Installation went smoothly. The only part that I didn't enjoy was drilling a hole in my brand new laser for the switch, but that's not Laser Artifex's problem.
Great video! Just got my kit, looking forward to installing it. Would also love to install a stack light. Do you have a source for them and a video to install?
I installed my kit with no issues. Easy to follow instructions. Works very well on my Ruida controlled laser with lightburn as the software. Much better than my "manual" adjusting of air that was provided by the wheezing little onboard air pump. Hooked to my shop compressor, cutting and engraving results are far superior. I'm not affiliated with Artifex - but credit where it's due - it's a good bit of kit and I recommend it. Cheers from Australia.
I have ordered it a month ago, but have not received it yet. Can you get back to me about the timing?
You the man.
What PSI do you set this to?
Just installed the kit and there is a small amount of air coming out of the nozzle with the machine off. Is this normal?
Yes this is normal when the machine is unpowered with the normally open solenoid. There is a manual valve to turn off air completely is the laser is unpowered.
Hello!
Realy like what you made!
This kit is amazing!!!
Did you send to Austria?
I wrote two Emails, but no answers😢
Hope you are ok?!?
Thanks!!!
We placed our order. Do you have an update on lead time? Purchase was made 7/21/2023
Works fine but my job is complete and turn off the laser, i still get low flow air coming out of the nozzle. This should not happen, right?
It's how it's designed. Even with the upgrade. It's a weird choice, not sure what the logic was behind it,
I've ordered one of these kits. I've heard good things about them, here in Australia.
Do you have a list of what to buy? For the pump assist? My pump will be here today
Are you still in business? I placed an order a little over a week ago, and have't had a response.
did you get your order? I am interested in ordering, but I have not gotten. a reply to emails with questions.
I did get my order, and it works great! Installation went smoothly. The only part that I didn't enjoy was drilling a hole in my brand new laser for the switch, but that's not Laser Artifex's problem.
What diameter PU tubing is used in this kit??
6mmx4mm PU
I need some troubleshooting advice.
The air compressor assist kit works when the laser is not running, turns off when the laser starts. Any advice?
Did you check the switch settings on the board or the software settings? The manual will have instructions on how to change these settings.