Not Software. www.buggiesgonewild.com/showthread.php?t=195876&highlight=Ev48-400-c&fbclid=IwY2xjawFlwbNleHRuA2FlbQIxMQABHcx03opsF0nq5ne9cZxsReqCDPEMEldaqf9PglNsTzL9CeB0FdTdYIOZzg_aem_d6mVzbOlP7pRUQNU0dG6Yw
Darmie: I want to express my sincerest gratitude for this video. I installed the software on a $75 used throwaway laptop from Amazon (because software from Buggies Gone Wild contains a virus, and it is too dangerous to install it on your primary laptop) and followed your instructions. They worked great and my 2025 Evolution D5 Ranger 4 now goes over 30mph, and I am no longer holding up traffic because cars would always like to go more than 25 mph and I always had to pull over and wave them past.
Great video!! I recently purchased a 2024 Evolution Classic and wanted to up the H/L speeds. Your video was spot on! Previously, I had an EZGO cart that had a Curtis controller and had purchased a USB-TTL Programmer interface device off of eBay. It worked great for the Curtis controller and also worked with the Evolution controller using the EV48-400-C software! Again, thanks for the great video!
I am at 25mph as well. I would really like it to do 32. Could you make it go faster than 32 if you wanted to? Just curious what the limitations are on this cart.
@@WILLIE3K I'm sure you can, but I have a 17 year old and don't want to take the risk. Also the main mechanic at Jack'd Carts didn't recommend anything over 30 because of the issues it develops and into his shop.
Tom - How did you get a copy of the software that does not contain a virus? Can you share it? Think software links I have seen on here all contain a virus when you try to install them.
Thanks for the video - very helpful. I understand there is a separate cable and program to get the cart history (not fault history). It shows trips length speed etc etc. Are you familiar with that?
I am sure you are sick of getting this question, but can you point me in the right direction of the software DL for a 24 D5 Maverick? I just ordered the cable. Thank you!!!
I would recommend checking out this website and select your cart. He he has a broken down to what your controller looks like to determine the right type of cable. If it is a 2024 evolution then chances are it will be the cable that I have linked to. Most of these controllers are based upon the year model as noted from his website. But just to be sure you can always remove the cover and take a look. www.cartcables.com/pages/evolution-electric-vehicles-controller-id-guide
It was set at 25. I got it up to 28. I've seen 29 one time on the GPS. since the manufacture sets the max RPM that's about all you can get. You can put higher wheels or tires but the RPM is the limiting factor so for my cart, 28 is it.
When you open up the software zip file you'll see there are some drivers that need to be run. Construction should be included on the software ZIP file.
Not Software.
www.buggiesgonewild.com/showthread.php?t=195876&highlight=Ev48-400-c&fbclid=IwY2xjawFlwbNleHRuA2FlbQIxMQABHcx03opsF0nq5ne9cZxsReqCDPEMEldaqf9PglNsTzL9CeB0FdTdYIOZzg_aem_d6mVzbOlP7pRUQNU0dG6Yw
Darmie: I want to express my sincerest gratitude for this video. I installed the software on a $75 used throwaway laptop from Amazon (because software from Buggies Gone Wild contains a virus, and it is too dangerous to install it on your primary laptop) and followed your instructions. They worked great and my 2025 Evolution D5 Ranger 4 now goes over 30mph, and I am no longer holding up traffic because cars would always like to go more than 25 mph and I always had to pull over and wave them past.
Mark, such a great story. Thanks for sharing.
Great video!! I recently purchased a 2024 Evolution Classic and wanted to up the H/L speeds. Your video was spot on! Previously, I had an EZGO cart that had a Curtis controller and had purchased a USB-TTL Programmer interface device off of eBay. It worked great for the Curtis controller and also worked with the Evolution controller using the EV48-400-C software! Again, thanks for the great video!
Thank you. I know the video is a little cheesy but the idea was to cut to the chase and point out simple things to change to get a little more speed.
How do you download the EV48-400-C software?
@@MarcusRobinson-ny9lg You can try these links. The software is not easy to find. www.buggiesgonewild.com/showpost.php?p=1906443&postcount=3
@@darmiejr My anti virus program blocks this software - says it contains a virus
@@mark090455 Any software install testing, do it on a laptop you can reformat. Use USB to install, don't connect to WiFi.
Worked just as he said. 25 up to 32 now.
I am at 25mph as well. I would really like it to do 32. Could you make it go faster than 32 if you wanted to? Just curious what the limitations are on this cart.
@@WILLIE3K I'm sure you can, but I have a 17 year old and don't want to take the risk. Also the main mechanic at Jack'd Carts didn't recommend anything over 30 because of the issues it develops and into his shop.
Tom - How did you get a copy of the software that does not contain a virus? Can you share it? Think software links I have seen on here all contain a virus when you try to install them.
That’s where I got them. I’ll put the software into Dropbox tomorrow and post a link to it.
@@tomhofferber5529 Thank you
What are the specific menus/categories/numbers to change to gain more speed? Screen shots possible?
Thanks so much for the video! Super helpful!
Is the program only for windows, and if so, is there a Mac/iOs version?
Welcome. I think it's only windows but may be able to use an emulator?
Only for Windows. I installed VMware Fusion on my Mac, created a Windows 11 VM, and had no problems running the software.
@@colinrblake that's good to know.
Thanks for the video - very helpful. I understand there is a separate cable and program to get the cart history (not fault history). It shows trips length speed etc etc. Are you familiar with that?
Not familiar with it but it would not surprise me that they take two different cables
Your video is very helpful. I'm not seeing the link for the blutooth battery app Thanks
It is on the evolution Facebook group under files. Follow the link that's in the description
Evolution 2024 programing cable
www.cartcables.com/products/programming-cable-for-2022-2024-evolution-ev
hi your video is great, i would like to know where can i get the EV48-400-C software. i cant seem to find it. thanks
Search the forums on Buggies Gone Wild. Have to do a little digging but its there. I just did mine yesterday.
@@trey9233 My anti-virus software says the stuff on Buggies Gone wild has a virus in it. How did you get around it?
I am sure you are sick of getting this question, but can you point me in the right direction of the software DL for a 24 D5 Maverick? I just ordered the cable. Thank you!!!
What cable do I need for an Evolution D5 maverick? And where can I get the program to change the speed? Can you share links?
I would recommend checking out this website and select your cart. He he has a broken down to what your controller looks like to determine the right type of cable. If it is a 2024 evolution then chances are it will be the cable that I have linked to. Most of these controllers are based upon the year model as noted from his website. But just to be sure you can always remove the cover and take a look.
www.cartcables.com/pages/evolution-electric-vehicles-controller-id-guide
@@darmiejr do you know were I can get the software?
How much faster did it make the cart
It was set at 25. I got it up to 28. I've seen 29 one time on the GPS. since the manufacture sets the max RPM that's about all you can get. You can put higher wheels or tires but the RPM is the limiting factor so for my cart, 28 is it.
What are the other pieces of software you have to have in the folder that you mention @ 6:40?
When you open up the software zip file you'll see there are some drivers that need to be run. Construction should be included on the software ZIP file.
Cannot find the software, where can the software be downloaded?
@@jackgrotrian5406 what year cart you have.
@@darmiejr 2024 Classic 4 Plus
@@jackgrotrian5406 Try those links.
You need the program with the C at the end like in the video.
www.buggiesgonewild.com/showthread.php?t=195635
Can you share link for the programming cable
@@jacksonfluck9835 www.cartcables.com/products/programming-cable-for-2022-2024-evolution-ev