How do you put the actuator arm back on to the waste gate mines poped off all waste gate lever in tacked its just come off all the turbo and manifold still on engine in van and need to put back on with out stripping it all out
My wastegate doesnt move at all. Its not seized though koz i can push it with my hand. What is my issue? Ive checked the pipes that i can see, they look fine. What can i check next? I can send vid if u give me an email or sumin
How do you put the actuator arm back on to the waste gate mines poped off all waste gate lever in tacked its just come off all the turbo and manifold still on engine in van and need to put back on with out stripping it all out
There should be a clip that holds the arm on. Sounds like it's come off.
Mines done the same I dont suppose you remember the size bolt you used. Was it a hex head or did you use something with a smaller head
Think it was an M6 and I trimmed the head down to get the correct clearance.
Can you turbo out without taking engine out, transit connect
Yes you can, I,m not saying it's easy but it is possible.
Many thanks for that
What do you think caused it to break? Mine has broken too, but I want to know the cause before I reconnect it.
I do not know, it may be a manufacturing weakness. I do know that once repaired it did not fail again.
My wastegate doesnt move at all. Its not seized though koz i can push it with my hand. What is my issue? Ive checked the pipes that i can see, they look fine. What can i check next?
I can send vid if u give me an email or sumin
Try connecting a vacuum pump directly to the wastegate to see if it moves in case the diaphram has gone.