So to anyone who may see this that is knowledgeable on these loaders, this was with throttle wide open. It's been doing this thing where the rpms will spin up to full throttle speed, but as soon as any load is applied it bogs way down, starts smoking, and I have to turn it off, let it sit, then start back up. Any ideas?
More than likely it’s something to do with the throttle when it bogs down when you apply the hydraulics or the engine is just down on power. You could test how much power it’s lost.
So to anyone who may see this that is knowledgeable on these loaders, this was with throttle wide open. It's been doing this thing where the rpms will spin up to full throttle speed, but as soon as any load is applied it bogs way down, starts smoking, and I have to turn it off, let it sit, then start back up. Any ideas?
Injectors?
Cold hydraulics thick oil
little turbo sound 😀👍
More than likely it’s something to do with the throttle when it bogs down when you apply the hydraulics or the engine is just down on power. You could test how much power it’s lost.
Might have water in fuel or bad glow plugs
That or your return line is clogged a bit id Check that too. Should not crank that hard and or idle that rough once up and running
What was the problem
I have the same issue
It was getting air in the fuel system from the primer bulb
Thanks man
Am have the same issue with the same engine I’m gonna change like you said was yours hopefully that is my problem thanks
change your fuel filter. id start there
Who built the engines for these?
Kabouta
This ones actually a deutz
@@backyardcreator2170 sounds like that starter is laughing
rev it
It’s cursed and jinxed to not start at all it’s hexed to not start at all
m8 play with your toes
pump your foot
............
rev it