If Your Nissan Has This P1715 Code From 2013 - 2017 Nissan Rogue | CVT BELT Worn Out Based Per TSB.

Please 👍 & Subscribe more video will post 5 times a week. @Auto Repair Procedures
❓ If you have question regarding about your vehicle repair/or technician has difficult diagnostic or repair. I'm hosting FREE Q&A on Zoom for 30 minute every week. Click link below to register.
✔️ autorepairproc...
Please Support This Channel On Patreon: / autorepairprocedures
Automotive Tools:
Autel Battery Test & OBD2 Scan Tool amzn.to/3ueXHOw
Visit my Blog: click below
autorepairproc...
My Video Production Gear:
GoPro Hero 8 amzn.to/3OzdxM2
Sony Alpha a6000 amzn.to/3Ap9ZaX
Affiliate Disclaimer: As an Amazon Associate, I will earn a small commission on qualify purchases. I personally use or have used the products from the links above that I feel quality products and I highly recommend them.
Disclaimer: This video is strictly for information only. If you are intending or performing any repair is at your own risk. We are not responsible for any of the damages to you and your vehicle(s).

[@Catdaddy0]

Hello, After using an ODB , this is what showed up
P1715 [0x1715]
SSB Inductive Signature Malfunction
SSB Inductive Signature Malfunction
Status: Validated fault present at time of request, Validated fault has been present during this drive cycle
Any advice is greatly appreciated.
Thank you

[@mariocuellar4000]

2015 Nissan Altima s, the code p1715 is showing up saying it’s “ input/ secondary pulley speed mismatch” what should I do? I can’t find anything online about it

[@autorepairprocedures]

There is nothing you can do my friend. You have a transmission problem. You have to bring your vehicle to transmission shop or dealer to rebuild or figuring thing out by them.

[@garrieparsons2265]

I can’t find transmission input speed sensor location Nissan sentra 1.8 2013 could you help please

[@autorepairprocedures]

It’s on the left side (driver’s side) of transmission.

[@keshyvi]

On my nissan rogue 2017..these codes come up-p1715, p0715, p0841, and p12f0. What do i need to do?

[@autorepairprocedures]

I would bring the vehicle to the dealer, so the dealer can perform the service.

[@haykgasparyannn]

Brother same p1715 issue but on 2008 altima , what you will recommend to do? Car only works on manual 1st and jerks on low engine speeds

[@autorepairprocedures]

What is the make and model of your vehicle? First, I would check the transmission fluid level. If the fluid is low try to top it off, make sure your vehicle leveled.

[@autorepairprocedures]

Is your Nissan Altima SV?

[@haykgasparyannn]

@@autorepairprocedures Nissan Altima 2008 L32 I bought this car 3-4 months ago , and how I can check the level of transmission fluid?
I did diagnostic shows only p1715 and p0720 , and symptoms are
1. On low engine speeds it start to jerk until I stop or drive
2. Seems like he is starting to get speed after 3000rpm
And thank you very much for reply

[@autorepairprocedures]

@@haykgasparyannnYour transmission dipstick will be on your right hand side, it’s the same side at the battery located. You push screw driver through the little slot on top of the transmission dipstick. You can go on Google type in “2008 Nissan Altima transmission dipstick”.
Your vehicle has CVT transmission. You can try to fix it by changing transmission filter, but I am not quite sure that will fix the problem. But certainly, you can try to fix it by changing the transmission filter.
Based on my experience CVT transmission commonly fails like this and early mileage (sometimes vehicle is not reach to 100,000 miles).

[@autorepairprocedures]

You bet my friend, trying to reply every messages or commons. I am here to help you out.