Видео

Hello, On a 2017 GMC Canyon V6, there are 2 Coolant Temp Sensors.. In your video, i see the one just left of the thermostat.. Can you tell me where the other sensor is located? Napa Part #ECH TS5839? Thanks for your help.

Hi there, my Chevrolet Traverse, engine miss fires/jerks specially when picking up the power like move at traffic light and start going on the bridge/hight plus the engine sound gets shattered. Plz suggest as I went with 2/3 mechanics and they say gear box issue for which I am not convinced at all though I don't have any technical expertise. Appreciate your support. Thanks

You never said what you did to fix it? What was the culprit?

Battery disconnect or not? How about fuel pressure release?

good caliper brakets bolts removal through heat treatment #👍👍

High neeping spring

What is the special tool that you are talking about?

Awesome I'm looking at this same issue today. Thanks bud

How far high can you jack up the motor so that you can put the tool to the tension slot.?

Does the back of the airduct fit in pins?

What socket sizes are you using for the negative and positive terminals? Also, whilst checking my truck I see the two screws that goes with the red bar are missing. What size can I buy to replace those?

Stupid video!

I dont understand the battery sizes man, online it says h6, cant find a size on the actual battery thats in there, looked it up it said size 48 h6 and here hes using a h5. The book says vehicles with start stop like mine take h5 like wtf bro

Why did you remove the coolant hose??

What yr dodge

No lube on the guide pins?

How did you cut it??

GOOD VIDIEO THAT I HAVE A THE SAME CAR FORD FOCUS MK3 DIESEL SAYING CRANKING TIME EXCIDED

Does freeze frame data show the maximum values that occurred? For example, for p0219 over rev code, does it show the lowest rpm required to trigger that code (even if the engine went on to an even higher rpm) or does it show the absolute highest rpm achieved after the code was triggered?

Im getting a p0882 n p0171 code. Battery terminal always corroded, not sure why. Should i buy new terminals to fix the p0882 code?

Anyone else triggered that he left that stone in the O-ring groove?

not one picture of a regulator- just video of how to open the door panel- important part is the door lock component on the top left- why it is still hanging

going to do my tomorrow thanks

Lifting these batteries out are inside

Wow all I watched for was to see how to get this crazy strap on and off and you just skipped over that part. Literally the only unique part of getting this battery out and you brush over it 😅

Y como se reparó la falla??

Are there any gaskets to replace ??

Any cabin air filter that is mounted horizontally will have downward air flow direction.

What did you say it’s called

Thanks for the upload. I’m changing both of the rear controls and trailing arm. Those bolts are rustyyyyyyy! Will definitely be implementing this. I don’t have a torch but I do have an induction heater.

Would be nice if you detailed the torque specs on the thermostat bolt and the outlet bolt ,lots of people goes by torque oem specs.

I changed one on 2016 Maxima , for $60 from Amazon .. didn’t have to unbolt the seat . Took 5 minutes

Am have the same problem and I changed the throttle with Homeuse but still talks about throttle position 1-2 correlation, I need your help

I replace mine now it wont start any idea

thank you

There is no mention of Gaskets on this install I would not want to attempt this procedure without knowing if Gaskets are needed. Especially if it's your only Vehicle.

Other than that liked the video, should have a little screen at the end or beginning of video listing the tools you used. Thanks

Can you please state the sockets that you used, couldn’t understand.

Will this work on a 2016? Driver side?

Hi I have a 2008 Saturn Vue 2.4L ecotec and I believe it's an LE5 engine. I noticed another commenter asked about water found under the dash and on the carpet. I had a somewhat related question. I wanted to clean out my evaporator core with evaporator cleaner but the instructions say to use the evap core/AC condensate drainage hose to do this. I have a service manual that doesn't show where the drainage hose for my engine is located. I saw you told the commenter who found water under the dash to clear out the AC rubber grommet, and that you blow shop air to make the water drain out. My two questions are: 1) where exactly is this rubber grommet located and 2) Is that grommet the evap core drainage opening? If it's not then can you tell me where it is. Much appreciated. BTW I use your video to learn how to do an initial teardown for when i need to change the evap core.

Dont u tighten control arm bolts with upward pressure on arms?

My car is idle In park and my check engine light on I replaced the purge valve about a year. I know air/gas ration is off. Should I replace 1st and could it be possible it will make light come off??

My windshield wiper switch on 1993 toyota corolla won't turn off! Help! Are you near New York & available to fix my wiper switch?

I have the same problem . Does it matter if u purchase the valve from autozone or does it have to be through dealership ?

Do you need to use some sealant?

Where’s part 2?

Horrible advice

That's fine if you have a torch but most people don't, average people have to use map or propane torches.

Shop manual states.. remove the motor.

Why do you need memory saver?