Burned DQ200 0AM TCU software recovery with MechaProg

Recovery software with MechaProg from burned DQ200 transmission control unit mounted in 7gears DSG with dry-clutch
mechaprog.com

[@niktgorszykazdylepszy4951]

Thanks for helping! I recommend it for all!!!

[@VladimirSokhin]

I see blue lines not violet. What about others pins on pcb? May be you have schematic diagram?

[@pro_avto_territoriya]

Есть ли такая возможность прошить плату без хвоста dq200 0cw и поставить вместо 0ам ?

[@mechasoft]

As i know, DQ200 G2 can be (if you find correct software) be used in place 0AM927769G/K. No direct 'copy' possible due to processor differences (TC1766 in old vs TC1784 in G2 units)

[@user-cs2bt4yf5h]

I have cople tcm dq200 to repair

[@asyrafmazlan809]

how to take old software to new tcm ?

[@mechasoft]

yes, this video is about, how to get old software (and all other settings) from burned TCU and transfer them to new unit (or pre-used).

[@autotechnikertt]

Why did you not just fix the TCU you already found the problem

[@mechasoft]

As you see, unit have oil inside (sensor leak), additionally it have short circuit on plastic board. This short circuit was caused by TCU (controlling motor for hydraulic pump) so it means - whole this part is overheated. From my experience unit same as this make smaller or bigger problems in future. We do not like do same car more times. It is reason why in same situation we mount new unit or used - fully tested control unit with very low working counter.

[@user-cs2bt4yf5h]

Where is your location

[@mechasoft]

Poland

[@huseyinozyilmaz2944]

Do you sell tcu ? Dq200

[@mechasoft]

Actually they are out of stock.

[@huseyinozyilmaz2944]

@@mechasoft can you give me your e-mail address?

[@mechasoft]

@@huseyinozyilmaz2944 [e-mail]

[@rightwingtrashrus274]

Kool and interesting video thanks, how much is the device and software

[@mechasoft]

@@rightwingtrashrus274 mechaprog.com