On my V11 Dyson the motherboard is covered in plastic like silicone to protect it - so I can't access the Torx screws holding the terminals in place nor can I un-clip the connector (the small piece you use your fingernail to disconnect). I can't remove the plastic / silicone over the motherboard. Have you seen this before?
On my V11 Dyson the motherboard is covered in plastic like silicone to protect it - so I can't access the Torx screws holding the terminals in place nor can I un-clip the connector (the small piece you use your fingernail to disconnect). I can't remove the plastic / silicone over the motherboard. Have you seen this before?
You can just take out the glue by using your finger nails , don’t use knife or flat head screw driver which could damage your motherboard.