How to Replace Parking Brake Cable 1995-2001 Ford Explorer

Buy Now!
New Parking Brake Cable from 1AAuto.com 1aau.to/ia/1ABRC00022
This video shows you how to install a new parking brake cable on your 1995-2001 Ford Explorer. A rusty, seized, or snapped parking brake cable leaves your car or truck in an unsafe state, especially if you need to park on a hill, or jack up the front in an emergency.
This process should be similar on the following vehicles:
1995 Ford Explorer
1996 Ford Explorer
1997 Ford Explorer
1998 Ford Explorer
1999 Ford Explorer
2000 Ford Explorer
2001 Ford Explorer
Tools you will need:
• Flat Blade Screwdriver 1aau.to/obch/1AXAA00013
• Pliers
• Anti-Seize Grease
• Rust Penetrant
• Hammer 1aau.to/oQp/1AXAA00091
Subscribe: / @trq
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@ricardoalbertorodriguez6408]

Desdé el león gto. México
Mil gracias el idioma no entendí nada pero lo practico de gran utilidad ya que tenía duda de como colocar pues el de mi troca estaba muy deteriorado.
Lo cambié en una hora de principio a fin.
Mil gracias

[@glenwhitestofer6420]

just bust the locking tabs off with a screwdriver

[@tomwordell6355]

Couldn't get brake cable attached to rear brake lever at very end.... had to unattach the cable at forward end of spring, attach end to rear brake drum lever and then re-attach end by front of spring. Bad sequence my friend.